How to remove the door panel from a first generation Mercedes R129 SL series follow me on twitter / fupabox
Пікірлер: 48
@JabokChannel8 ай бұрын
Thanks SO much for this fantastic video! I was working on a buddy's '92 500SL & I was ready to just rip off the panel and deal with his righteous anger afterward! Thanks to you, I didn't tear up his door panel!
@chrischurch44898 жыл бұрын
great video, I need to remove door panel on passenger side to check/replace the speakers - very distorted sounds and its not the music! Thanks for taking the trouble to film the work - I'd never have found all the hidden fixings Chris
@williamkennedy54923 жыл бұрын
Really good information here thank you, Cheshire UK
@brynabryna4 жыл бұрын
Your videos ARE THE BEST!! I reached out to you before about the hydraulics above the passenger side windshield, but my power windows just stopped working so, those are next! I just made a short video- not as detailed as yours- about replacing the lower air seal. I'll upload it soon! Though, I am looking for a video on how to fix the window- mine is having trouble going up and down- my neighbor says it's the window regulator.... It's making an awful clicking noise and sometimes the window "falls" just enough to hear wind cooming through it.
@fupabox4 жыл бұрын
that sounds like the regulator . Likely the teeth on the large pivot gear are stripped ,which would cause it to not stay all the way up . Could be the smaller drive gear too . Replacement of the regulator is likely the only fix unfortunately .
@dr.jackkhorram41292 жыл бұрын
Thank you for your information regarding the mb
@CantKillMe10 жыл бұрын
thanks for the info
@capriceproduction53672 жыл бұрын
Thanks a lot , Merci beaucoup ... Très très bon Tuto ,
@rioraton6 жыл бұрын
Another very informative vid! I was just going to ask how you change the door light out and BOOOM! you show how to remove the lens and get to the bulb. Going to replace with LED bulbs cuz mine are so dim.
@fupabox6 жыл бұрын
The LEDs make a nice bright light when the door opens .. way better than the stock ones
@RobertSmith-di5ll4 жыл бұрын
How do you get the lid off the map pocket ? It seems to hang on at the door latch end - does that screw in the end tie it down?
@melkonindjarabian4818 Жыл бұрын
Do earlier models of r129 have suction doors or soft close?
@vomgraph8 жыл бұрын
great information. I had the window regulator replaced on my wife's SL320 recently. now the window on drivers side does not do the auto 1/2 inch drop as it is supposed to? The mechanic told her that there is something located right next to the window motor? that had do be damaged when the motor "blew up" first off the window had jumped out of the track it still went up and down properly just jammed half way up, secondly I did not know there was anything connected to the door latch that had anything to do with they auto drop on the windows>
@fupabox8 жыл бұрын
there is a switch on the door handle latch that lets the window know you have opened the door, or closed it. since you replaced the regulator you should reset the window syncing ..make sure all doors ,trunk ,hood closed..turn key on and press and hold window up switch..keep holding 10 more seconds after window raises completely..press down and hold 10 seconds after window is all the way down..do both windows a few times... Then using the red roof raise/lower button...do the same raising and lowering the roof. except hold a further 20-30 seconds after top is all the way up, and all the way down. This should allow the windows and roof to all resync as to where "up" and "down " are. The window motor counts turns of the motor to determine if it is up or down, or in the "drop " position
@ProtegeTuype9 жыл бұрын
I believe the air vent is gor difrosting the window
@thaddeauscaldwell71015 жыл бұрын
As always , I enjoy your videos . They are very informative. Thank you for posting them . I have a 1995 R129 and a 1996 R129 . Even though they are similar, they are different too . How do you remove the long wood trim from the 1996 R129 doorpanel ? Can it be removed without taking off the doorpanel ? If it can , how do I take it off, without damaging it ? I've Googled to find this information but haven't found it . Thank you again for the great videos.
@fupabox5 жыл бұрын
I believe the doorpanel has to come off and there are compression press washers on the back that push onto studs on the wood trim strip . It wouldnt come off with the door panel on
@thaddeauscaldwell71015 жыл бұрын
@@fupabox , I was hoping that the strips snapped into place . It'll just be a little more time consuming. I'll check it out . Thank you for the information.
@bexaminer18 жыл бұрын
Nice detail on the panel removal. I want to replace the two Bose speakers on the passenger side. I have a 2001 SL. I was hoping that there was a way to simply remove the cloth panel covering the speaker and avoid removing the entire panel. Is that something that can be done on the 2001?
@fupabox8 жыл бұрын
+Jim Graves no unfortunately, even the later models have the speaker grille covers attached internally
@raiderman289 жыл бұрын
great video, I need to remove door panel on passenger side. the window will not roll down, it all the way up. I hear the motor. I bought the car used. I don't know if someone disconnected something from the motor to the window. you mentioned a micro switch.... and said it tells window to go up or down. I wonder if this could be the issue. do you have a video on replacement of this switch???? thanks
@fupabox9 жыл бұрын
Raul Romo the micro switch is on the bottom of the inside of the door.. it's basically a rubber pad that the window touches when down...the roof controller reads this as either up or down...if the switch shows anything other than up..it will lower the window when the roof is actuated..the window switches over ride it..
@billclark82414 жыл бұрын
As far as heat going thru the doors my guess would be to keep the interior of the door more dry. All makes allow water to get by the window "seals" so why not minimize corrosion to speakers and the other electronics. Sorry if already mentioned but wasn't going to read all the comments. I noticed the vents myself but never really thought more about it after seeing it the first time. Watching your video made it click for some reason in my memory- don't know if correct but will ask a few people.
@fupabox4 жыл бұрын
makes sense.
@billclark82414 жыл бұрын
@@fupabox am I the 1st one to give you the "heat-keeps-door-electronics-drier" theory?
@fupabox4 жыл бұрын
@@billclark8241 i think so. I've heard many other guesses as well. keep door panel warm, keep window lubricant from getting sticky, locks from freezing , All possibilities.. An enigma..lol
@Steve-ec6ed5 жыл бұрын
I’m having an issue with the door handle on my 99 SL. It’s slightly loose, not terrible but just enough to piss you off. Since you’ve had a bunch of these panels off I’m wondering if you know how difficult it is to access the door handle to tighten it? I’m assuming it’s a screw or nut that just needs tightening?
@fupabox5 жыл бұрын
m.kzbin.info/www/bejne/f4vQpKKwp7KJjrs
@wanakin79 жыл бұрын
heat eliminates moisture buildup??
@fupabox9 жыл бұрын
Pat Hagan yeah, maybe... I really don't know
@solstice66610 жыл бұрын
Which year is this from? Have a 93 R129 here and these damn hinges on the map boxes under the arm rest are broken.. Looks very similar to yours. Are you parting that car out?
@fupabox10 жыл бұрын
yes I am...but these ones are broken as well...most of them are..they screw into the hinge piece from behind the door panel and the plastic rods they screw onto break very easily...the dealer fix is to either replace (over $400 parts labor) or put a few wide headed black screws through from the front,which is what you will see on most of the SLs out there
@solstice66610 жыл бұрын
***** have you ever had the drivers side seat control act completely eradic, where when you move headrest for instance it moves your seat, and when you move seat its backwards? If you are parting i may buy some components from you.. just contact me via PM.
@Onidax4 жыл бұрын
@@fupabox Can you recommend what size screws / drill head to use?
@williejohnson58059 жыл бұрын
How can I manually put my top down when the pump is not working and is leaking get fluid
@fupabox9 жыл бұрын
willie johnson this video shows raising manually, just work in reverse to lower kzbin.info/www/bejne/g6a5eWeqr7tsirM
@DopefishOG5 жыл бұрын
I have a 1999 SL 500 and the doors are really heavy when opening and closing. Can this be fixed?
@fupabox5 жыл бұрын
grease the flat bar going into the door around the midpoint between the upper and lower hinges. It's the friction door holder. When not lubricated it will make the door hard to open and close
@brynabryna4 жыл бұрын
Do have a video of you replacing the window regulator?
@fupabox4 жыл бұрын
No sorry I don't. I have never had to replace one in a R129. This should help www.pelicanparts.com/techarticles/Mercedes-W129/36-BODY-Power_Window_Removal/36-BODY-Power_Window_Removal.htm
@brynabryna4 жыл бұрын
@@fupabox This does help! Thank you!
@stephenbooth967710 жыл бұрын
These door panels and the vacuum locked door pockets are a pain and fiddly to repair. My car has several botched repairs on broken hinges glued back with Aruldite and now really difficult to remove and do a proper repair job with new hinges. I guess the door heating stuff is maintain as dry a door interior as possible. It's a small effort to cut down condensation.
@RobertSmith-di5ll4 жыл бұрын
howw did you get the pocket lid off?
@dylanmorse2 жыл бұрын
Thansk
@dylanmorse2 жыл бұрын
Thanks
@johneffinger92578 жыл бұрын
The heat is to defrost the windows.
@fupabox8 жыл бұрын
+John Effinger that makes sense..but would it have any effect with the windows up ?