Mobile alloy gator installation / uncut video tesla model y

[@realbrosautopros1171]

Buy now on Detailprotools.com

[@czamman]

Some videos show metal clips that need to be glued to the saver before installing it. I didn't see you installing them. Did you install before or does the pressure from the tire keep the saver on? Thanks

[@realbrosautopros1171]

I for got to put this in the video and yes you have to put the clips in but I don’t apply super glue on the clips but I will keep in mind for the future

[@redbaron2448]

😂😂😂😂​@@realbrosautopros1171

[@AGREVLE18]

Did You use the suitability gauge? Can You tell us what is the lenght of the green area of the gauge?

[@Otiesh]

Wow this one's looks much better than the ones that you just stick on

[@bobbg9041]

Critical mistake putting any part of your body under the car if its just on a jack, any kind of jack. If the jack bleeds down or somone hits it, is there room for your legs and feet under the car? I dont think so low profile tires and a low body stance also no air in the wheel = crushed feet and legs and your stuck under the car.

[@realbrosautopros1171]

Will keep that in mind for the future thanks

[@jacobheinz8236]

This is asking for troubles with a capital T ! Banging away at the wheel when it’s just on a hydraulic jack, lol. Obviously this dude have never seen how such a jack could suddenly fail and drop down with the car on his legs etc. Seriously bad YTube example for others, doing more harm than good. SAD man!

[@hvu6037]

The wheel he was working on still attached to the car. So even if the jack failed and the car fell down to the ground, all four wheel/tires would be there. Your comment had no basis.

[@JoseLuisCuevas-o2s]

What or they for are they some type of protection for your wheels😮

[@realbrosautopros1171]

Yes they protect the wheels edge

[@PetesShredder]

You didn't glue the little tab thing over that joins the two ends together

[@realbrosautopros1171]

I apologize ,but that step is pretty self explanatory ;)

[@realbrosautopros1171]

I have a new video with better explanation

[@Steppiliha]

​@@realbrosautopros1171 this whole application is kinda self explanatory 😉

[@Otiesh]

What are they called exactly and do they also work on tubeless tires

[@ferrari458it2]

Hello, are these wheel protection rings safe enough and there is no risk that they will come off while traveling at high speed?

[@realbrosautopros1171]

Please install properly

[@ilker8608]

1:05 what is this liquid?

[@alexhahn7607]

The black paint is now gone from the rim under the cover, if you remove it by hard acceleration you see the pure aluminium. Good Job.

[@realbrosautopros1171]

I’m confused on this, can you elaborate more!

[@realbrosautopros1171]

The rim is now protected from getting scratches on the front! Face of the rim, now if removed with a curbs hit them I believe the alloy gator will safe the face of the rim, the alloy gator is made of plastic

[@yujonathan6352]

What color are you using on the model y? Black or Graphite?

[@realbrosautopros1171]

For this video it’s black

[@markcain5168]

The hammer is called a Dead Blow Hammer.

[@Osiriswear]

Umm how do you get the wheels to turn when jacked? Model Y wheels seem stationary when in park & jacked.

[@realbrosautopros1171]

Go inside close doors and put the car in tow mode in the settings make sure you put something on the other wheels so it doesn’t roll back

[@bigredlibra]

Does the alloy rim piece you installed dent from the hammer?

[@realbrosautopros1171]

No it should not

[@MrInstag8tor]

Wish i knew about these before i bought my Laramie midnight edition 😞

[@agentmrp]

I brought these and they didn't fit in properly. I also didn't put any soapy water on them. Could this have been the reason they didn't go all the way in?

[@realbrosautopros1171]

Yes most likely they also have to be hit with the hammer pretty sturdy, and to make sure it looks nice and even

[@Jafear]

Where did you buy that from?

[@firmbutton6485]

What weight hammer is that?

[@realbrosautopros1171]

This is a plastic rubber hammer with the little pebbles inside it’s metal free

[@vecterprime2621]

These trap water and road salt and in the winter will cause the wheel to corrode

[@BarnyDaddy]

Does it stay on during tire change?

[@realbrosautopros1171]

No you must have them re applied by the company who put it on

[@leeyo5494]

@@realbrosautopros1171 thats the biggest downside

[@luiznascimento5567]

Boa noite Aonde acho esse friso para comprar Só acho adesivo Gostaria desse modelo

[@realbrosautopros1171]

está na bio detailprotools.com or alloygatorwheels.com

[@Slamjam88]

Not sure if I want to hammer those on my $10,000 wheels 😅

[@Marko-hr4rj]

Bro is still tapping

[@realbrosautopros1171]

😂😂

[@fortijr]

LOL - thanks!

[@zackattack1188]

Looks pretty easy.

[@realbrosautopros1171]

Yeah it is just need the tools

[@carllicari3067]

Until you get to the rear wheels that don't rotate

[@zackattack1188]

@@carllicari3067 You lost me.

[@alextinpin3577]

You paid about 56K for this car and now you do stuff that Tesla should do get the f truck man .

[@realbrosautopros1171]

😅😅 curb rash happens on trucks too and the alloy gators fit them too

[@johns3153]

​@@realbrosautopros1171not if the tires are higher then curb lol

[@Skizm_admin]

Cowboy 😂😂