I just bought on swap and shop for cheap and about to do a full rebuild. Good video
@Deucealive7511 ай бұрын
That clutch assembly is pretty nice. May make the rest of the gearing easier. No need for a large sprocket on the axle. Only bad thing about using RTV is that you have less endplay for the output shaft than you would have with a gasket. Other than that it doesn't matter. If i knew the clutch pack was serviceable and parts were available I would use trans fluid.
@Crojagg15 ай бұрын
what air filter are you using and how did u put it on? can u do a tut on it please
@MechannibalGarage655 ай бұрын
I measured the inlet of the carb at 41mm, so I ordered a filter with a 41mm opening,
@darintraver49835 ай бұрын
Can you tell me what the main jet is ?? 100 or 110 or ?
@Nicko1264610 ай бұрын
Hey dude I commented on the junkyard pw80 video just wanted to know what flywheel you bought for it need to know as I’m fixing one
@MechannibalGarage6510 ай бұрын
It was just a generic one off ebay
@famousboi6580 Жыл бұрын
Where would I get a wet clutch?
@MechannibalGarage65 Жыл бұрын
Bought it at a swap meet. Amazon & Ebay sell cheap ones though.
@nickpike59517 ай бұрын
Where can I get that gearbox?
@MechannibalGarage657 ай бұрын
I got mine from a swap-meet but here's the amazon link amzn.to/3yogGLF