Modernized Air Brake test.

[@alexvalencia3721]

Thank you for this video. My test is Jan.7 hopefully I pass I will continue to study hard!!

[@mikelogan99CDLClassAskillstest]

You got this!

[@KollynBrown-yk5st]

Thank you I’m in school rn and gotta test on it today

[@mikelogan99CDLClassAskillstest]

Good luck!

[@stevenjordan-j5b]

Video is helping me.. I'll graduate on December 10th... Hastings NE

[@mikelogan99CDLClassAskillstest]

Congratulations

[@cjur1]

Thank you sir

[@cjur1]

🎉 I am first

[@cjur1]

Taking my test December 1 2023 with me luck

[@mikelogan99CDLClassAskillstest]

So nice of you!

[@btaylor8849]

​@@cjur1did you pass

[@lonesomecricket7721]

Why do some people show counting the seconds between 85 and 100 on air pressure buildup?

[@mikelogan99CDLClassAskillstest]

It may have been part of the test years ago but not anymore. The purpose is checking to see if the Air compressor is working properly. If you're building pressure at what seems to be a normal rate trying to get to "Governor cut out" it's not necessary to time this.

[@kinglui374]

Do you have an air brake leak test video for just the tractor with no trailer attached?

[@mikelogan99CDLClassAskillstest]

No, all of the videos in this series pertain to the CDL test in a Class A vehicle. You're referring to a Class B and the test is the same except for the parts that pertain to the trailer.

[@kinglui374]

@@mikelogan99CDLClassAskillstest so when doing the air brake leak test on tractor only, I only press my tractor parking brake in and not my trailer brake correct?

[@mikelogan99CDLClassAskillstest]

Correct

[@mikelogan99CDLClassAskillstest]

Yes, you’re correct 👍

[@temitopegbolagade5864]

For automatic transmission you will need to choke the wheels.

[@mikelogan99CDLClassAskillstest]

That’s correct.

[@temitopegbolagade5864]

@@mikelogan99CDLClassAskillstest The Texas DPS at Grand Prairie failed a student for air brakes test when he got to the EMERGENCY BRAKES TEST. He called the valves trailer brake valves and tractor brakes valve respectively, the lady examiner said for emergency 🚨 brake test they should be called service line and emergency brake. Checklist inspection descriptions did not call it so.

[@mikelogan99CDLClassAskillstest]

@@temitopegbolagade5864 I hope people read this because this is very unfortunate. It's called the "Tractor protection valve" in the CDL handbook. That's the correct name. This CDL test is based on the content of the material in your states CDL Drivers manual and it is a requirement that you name parts and components by the correct name. On the checklist That you're allowed to carry with you on the test it refers to "Parking and Trailer brake test". I would dispute this because he's correct and she's wrong. With that being said, you're not allowed to use slang words to describe a part or component. The valve itself say's "Trailer Air supply" It doesn't say service line. You test it the same as the emergency brake. It's design is to apply the trailer brakes in an emergency if the trailer breaks away from the tractor. Good luck with this and thanks for sharing!

[@temitopegbolagade5864]

We are advised to just say (Emergency brake valves) will pop out for this emergency brake test which is the 4th. Guys who said emergency brake valves passed and those who said tractor protection valves and service brakes failed.

[@temitopegbolagade5864]

We are advised to just say (Emergency brake valves) will pop out for this emergency brake test which is the 4th. Guys who said emergency brake valves passed and those who said tractor protection valves and service brakes failed.

[@TroySweet-f8e]

Just fyi I failed my test today in Arizona by saying “at approximately 60 psi.” I was told it’s “at” 60 psi.

[@mikelogan99CDLClassAskillstest]

That's very unfortunate because the test is based on "specifically" the information printed in your states CDL Drivers manual. My state is Colorado, which all states are the same says; The low air warning (Buzzer, Light, or flag) should activate before air pressure drops below 55psi or a level specified by the truck manufacturer" If I'm testing you I want to know if you understand the low air warning system and that it will automatically activate at a certain air pressure. If you say approximately or at 60 psi I would pass you because you do understand what happens. I don't know who tested you and failed you but I would dispute this. You're more correct that the examiner!

[@warrioroutlaw6231]

What doing your 100 psi Cut In?

[@mikelogan99CDLClassAskillstest]

The truck was initially at 100 psi and he started the engine, idling it up a couple hundred rpm and waited to here the purge of air that indicated the governor cut off and it stopped building air pressure at approximately 125 psi. That’s a full charge of air that you need before you start the air brake test. If this doesn’t address your question please explain. There’s nothing in the air brake test about a 100 psi cut in. The compressor always builds air until it cuts off at 125 psi.

[@warrioroutlaw6231]

@mikelogan99CDLClassAskillstest at my cdl school, we start. 1. Chock Wheels 2. Get in cab, seat belt on, brakes set, gear in neutral, and turn key to on position, and say checking see abs and abs trailer light come on and off, and my deff light comes on and off 3. Going dona safe start, finish my 4 way, left and right turn signal, high beam working. 4. The do a vehicle cut in and cutout, this vehicle cut in at 100 psi, and my cut is is between 120 and 140, this vehicle is approximately 125. Now release yellow brake and do cut in at 100 psi and to make sure air gauge working properly, then tap lightly on brake pedal, air Guage should drop under 100 0si to indicate p Proper working Air Guage. 5. While Air psi build up To governor cut out, I'll start my in cab inspection.. 5. Once in cab finished, start air brake test, w8th air Guage and govorcut off, this v3hicoe cut in at 100 psi and cut out between 120-140 psi, and this vehicle is at approximately 125. The start down the rest of brake test...

[@mikelogan99CDLClassAskillstest]

My video is only the required Air Brake test. This is required to receive a 100% "everything correct" score or you will automatically fail. You're making reference to the in-cab inspection and you are not require to score 100% but try to get a good score. There is not an Auto fail for the In-cab inspection.

[@ada-boy]

You "released" the tractor breaks twice. 😂

[@mikelogan99CDLClassAskillstest]

No, the video demonstrates the test exactly as it is required pertaining to the CDL drivers manual.

[@NoName-q4i]

Seat belt you failed

[@mikelogan99CDLClassAskillstest]

This video in the series demonstrates the procedures for conducting an air brake test which needs to be performed accurately without any mistakes. Wearing a seatbelt is mandatory during the road test and it’s an inspection item during the Incab inspection. Wearing a seat during the air brake test is not required.

[@temitopegbolagade5864]

⁠so basically the first in cabin test is the air brakes?

[@mikelogan99CDLClassAskillstest]

Yes, that's the sequence on the check list.

[@STEVEOfromSAN.FERNANDOca]

Cuz didnt do the safety start test . Annnnnnnnnnnnnt. YOUVE JUST FAILED, YOUVE JUST FAILED😂 YOU DONT HAVE MAIL. YOUVE JUST FAILED😂. IM JUST KIDDN BR. THANK YOU FOR YOUR HELP. MY TEST IS WEEK AFTER NEXT 4TH OF SEPT. GOD BLESS BRO🙏🏽