Mopeka Propane Tank Sensor Battery Replacement

[@valq661]

Thank you for that tip! I had no clue how to do it!👍

[@tomm9493]

I just set two sensors up today in prep. for hurricane Helena. Works great. The tanks are outside on the other side of my house and sitting here in the livingroom using the app I can see the propane level percentage. Cool.

[@nelsonfigueroa5609]

Thank you for your tip and instructions. Regards from 🇵🇷 Puerto Rico.

[@kathyhill6753]

Thanks! I use this sensor, too. Love it! Yep, the battery last me a year. Thanks again for the info. Very helpful!

[@TheNorthwoodsRVLife]

Thanks for stopping by and watching! hope to see you around some other videos as well.

[@dennisgardner7991]

Very good video. I just replaced one of my batteries and this video made it a snap to do. One thing the video doesn't show is the rubber seal that fits in a groove around the bottom half of the sensr body. I had to be careful, especially around the green button, to make sure the seal stayed in the groove while re-assembling the halves back together.

[@cpwatching5647]

Just subscribed. Your videos are great. Helping me with RV maintenance for sure. Take care.

[@ferdinanddekeersmaeker1686]

Thanks man for the info . greatings Ferdi De Keersmaeker from Antwerp in Belgium

[@TheNorthwoodsRVLife]

thanks for watching

[@massi1778]

Thanks from Spain!!!

[@greysfreak1992]

Thanks!!😁😁😁 ours has been saying low battery for a while and I didn’t know how to change it

[@khangnguyen5823]

Thanks for the video!!!

[@markhartley5708]

Nice video, but you might want to show everyone how to replace the battery in the other piece, the tank guage indicator, as well.

[@TheNorthwoodsRVLife]

Ok next time

[@traveldreamer4616]

Nice sensor. I will let a friend know.

[@TheNorthwoodsRVLife]

thanks for watching, hope to see you at M22 meetup

[@jordlc3480]

That knife was giving me anxiety good vid thanks 🙏

[@TheNorthwoodsRVLife]

lol thanks for watching and taking the time to comment!

[@RVingwithG]

Good to know. 👍

[@OrganizedMud]

What did you use for the gel on the sensor after replacing the battery?

[@TheNorthwoodsRVLife]

You can use just plain old dielectric grease. But to be honest, I've never used any gel on them and have never had a problem with the sensor reading correctly.

[@alwaysathomewhereverweroam7955]

You need to reset and sync the sensors after you change the batteries?

[@TheNorthwoodsRVLife]

they will more than likely need to be reset, i haved changed them before they were completely dead and didnt have too, but more often than not they will likely require being resynced

[@lb7wade518]

Just changed my battery’s and will not scan now

[@notagain8661]

Has anyone ever had there sensor fall off the bottom of their tank on the hwy? Wondering if some tape on it would help hold?

[@TheNorthwoodsRVLife]

I personally have never had one fall off, but on our RV the pan that holds the tanks in place is solid underneath so they would not have a way to fall out, other RV's may be different, thanks you watching!

[@notagain8661]

@@TheNorthwoodsRVLife Yeah mine is open to the road on the bottom, so not sure the bumps wouldn't throw it off?

[@croxalls]

We use a piece of utensil drawer sponge cut to fit our tank rails, if the sensor were to fall off it would be caught in this.

[@TheNorthwoodsRVLife]

@@croxalls thanks for watching and commenting!

[@madogblue]

CR2032 BATTERY