Motobilt JKU Round Tail Light Conversion Install - W/ TIMESTAMPS!

Ahead of some other future modifications, I went ahead and installed the Motobilt Round Light Conversion kit on Oxylus. This ended up making for a longer video, so below is the list of timestamps for specific steps through the process. Install took a couple days, mostly just because of the painting, clear coating, and letting it dry before doing more work in that area.
TIMESTAMPS
00:00 - Intro
01:42 - Set Up
03:22 - Removing Tail Lights
03:44 - Removing Metal Clips
05:00 - Grind Flat
06:13 - Mark
06:37 - Cut
09:38 - Smooth Edges
10:02 - Clean & Paint
11:00 - Removing Metal Clips (Passenger Side)
11:22 - Grind Flat (Passenger Side)
12:03 - Mark (Passenger Side)
12:16 - Cut (Passenger Side)
13:17 - Smooth Edges (Passenger Side)
15:01 - Clean & Paint (Passenger Side)
15:06 - Quick Tips 1
17:03 - MotoBilt Wiring Diagram
17:23 - Factory Wiring Pinout
17:43 - Wire Splice Guide
18:03 - Resistor for Rapid Flashing
18:23 - Quick Tips 2 & Position
19:07 - Mark Holes
19:20 - Pilot Holes
20:17 - Widen Holes
20:33 - Align
21:21 - Bolt Length Note
22:12 - Longer Bolt & Loctite
23:11 - Dropping Fasteners
25:20 - Rubber Grommet
25:41 - Lubricate Grommet & Install Light
26:08 - Light Test
26:16 - Wrap Up and Final Notes

[@patricksullivan9713]

I like all the diagrams you included in here, I just recently ordered these lights. Thanks a lot!