Must Have Upgrades- Arrma Limitless & Infraction 130+ Mph Test

[@AussieRCPlayground]

Nicely done. And the sound of that pass was just awesome!! Looking forward to running mine when the time comes. You're gonna be hard to catch. 😜 Thanks as well for the mention and glad I could help. 👍😊

[@AussieVeteran71]

Insanely fast , nicely done 👍

[@brianthekid9]

Great showing Brandon, ya the sound when passing , sound different and better😁

[@derjoh1986]

To be honest, it's most likely that most, if not all driveshafts will shake at a certain rpm threshold but usually straighten out at a given top speed run. When you start to slow down from that high speed run, the drive shaft would began "shaking" again until you go below a certain rpm threshold from the run, then the "shaking" would stop at lower rpms. By having the car off it's wheels, like the demo I saw at the beginning of the vid, the shaft shakes more violently because of a less torque load. Although your newer, thicker driveshafts look impressive , they'll still indeed shake at a certain rpm range. You would still have to balance them in order to minimize the shaking effect. Do the same freewheel test with the new, thicker shafts and you will see what I mean. The drive shaft has to be ridiculously balanced in order for that vibration to be minimize further. Then you would have to balance the drive shaft cups that holds the driveshafts as well. Although the speedrun you performed was very impressive indeed, I still heard a little of the famous whining sound in your vid that every speedrun car does but in your defense, I heard a bit less of it. The stock driveshaft should hold up fine. People already proven this with speeds over 150 mph with the Limitless. I'm sure you had seen people, like Phillip jolly, even break the 150 mph record many times, all with a stock driveshaft. Excellent video nonetheless 👍

[@earlmoorhead5555]

Hopefully they get them in stock soon say mid October I really like to get a set thanks for the video

[@rpetit2079]

Looks great. Where can I purchase that shaft

[@bradandmarksrcgarage4940]

Good job Waqar that wing is amazing

[@rippedkraton7036]

Really nice set up and neat work dude!

[@rcbustanut2057]

Excellent info bro, I just snapped the rear dogbone on my Limitless only after day 3 of setup test runs. I didn't even get past 83mph, was only running stock setup with ESC set slightly conservative since this is my 1st time running a Limitless. Running the MMX 8XS w/ 1717 1650kv motor. I noticed the same thing, there was serious wear on the dogbone & the braces. So I just replaced both front & rear with heavier duty versions made by RCAWD. #45 Hardened steel & thicker. These rotate much smoother & straight. Eventually I will probably replace them with the Scorched 8mm titanium version. They were out of stock so I went with these other guys. Excellent content as always! 😎👍

[@birminghamgtrc]

Sick set up bruv love the drive shafts I have to get me some of them. And the rear wing is 10/10 boss sickest wing I've seen by far. Looking forward to seeing you push big number hit them 150mph+ if you find the right spot as I know your spot is to short but I can see you hitting 140mph their.

[@vinsanitysmet]

Can't wait to get my amped RC upgrades in the mail

[@72nivo]

Absolute Beast 👊🏻 Nice upgrades man. Markhor makes some great stuff 👍🏼

[@godsun358]

Very smart buy bruh that shaft is ready for some hits

[@punzi5639]

What kind of fans are those?

[@operation11charlieinc]

Crazy fast,,, awesome stuff brother

[@philipjolley1015]

Wing looks great. shafts will help also. nice pass.

[@vinsanitysmet]

That sounded much smoother than the stock drive shaft going down the road

[@supaa11]

Could you give me a list of all the upgrades you did to that armor limitless please and thank you

[@DeRock401]

Why do some people give the rc a tiny little push start when doing these?

[@InnovationRC]

Cogging at the start. When you push the car won't cog

[@TomleyRC]

V Nice... I love Carbon Fibre.... nearly as much as Chocolate!

[@RcAVENTURE.V.F.R]

Waouh great all those upgrades of parts in carbon and aluminum, I guess the car has lost a little weight with the parts in coal. Thank you for sharing, greetings colleague from Paris France

[@teslacybertruck750]

Best looking Limitless, no doubt!.

[@pkr150]

Awesome carbon kit lovin mine!

[@y-adre-eastoaklandrclife9544]

Who makes that drive line again?

[@istevemackanixs]

Were can u get the upgrades from fro the infraction

[@bigboytoyzrc9258]

Have you upgraded the center drive shaft? I've heard the vibrations can cause issues at high speeds.

[@mikeinvegas1]

I subscribed. For me to get a car built like yours do i buy a roller first? How do i start the build. Complete list so i can start the journey;) and roughly how much would cost.

[@joeycrack509]

To make It run, motor / esc / servo / transmitter / receiver / cap pack. I been building mines 2 days now after work, killmode 2900kv / xlx extreme / savox 7.4 / spectrum dx5c kit. That's my direction the rest is your finger print that makes your own. Check out rcmonsters.com I'm liking on those upgrades but I'm digging the carbon fiber so hard to decide. Keep on keepin 👍😀

[@joeycrack509]

Take your time with your build a little here a little there till you have all your parts, black Friday is the greatest time for rc hobby builds. Have fun with your build you get back what you put in.

[@christopherjames8978]

Your motor wires is white red black red being the middle is that how I'm supposed to hook mine up read middle white then black on the outside please answer

[@InnovationRC]

Plug red in the middle, then white and black on either side. If vehicle goes in reverse. Reverse polarity by switching black and white. Then recalibrate the esc

[@christopherjames8978]

@@InnovationRC okay thank you I have the same setup as you in the video just with the 8's motor

[@todaystopic8345]

What kill mode motor is that, is it the 2700 kv or 2900kv?

[@loumitchell3025]

Nice video can you tell me where you got the fans from 👍

[@InnovationRC]

Thank you! It is a one-off system I made myself

[@vinsanitysmet]

Solid!!!

[@truboy555]

I was working and heard that thing pass and said Got damn...lol Flash baby!!!

[@speeddemon2152]

Clean looking build. Waiting on parts to be available all sold out as of now. Question. What battery tray are you using? I’m debating on making one out of carbon fiber

[@shameelali2549]

Nice what power system do u have

[@speedfreak1161]

Do you need the Aluminum chassis brace with the 8mm drive shafts or can you run the stock plastic ones ?

[@InnovationRC]

I have seen some guys use it with the stock chassis braces with little modification, but I would really recommend getting get them regardless, ensure a proper fit

[@antonioviernes2500]

Where you buy the wings and the body support? Thanks

[@InnovationRC]

If you listen to this video with sound I state where I did, click the video description to find the links

[@302BAGGER]

Killer brother !!!!

[@Ch_kostis]

Its so quite and stable

[@robsr.5518]

Hi guy, Wear did you get the drive shafts from.

[@notrcmaskedmaster4374]

✌🏻😎🏴󠁧󠁢󠁷󠁬󠁳󠁿 That was just a warm up run lol. Freaking fast for a warm up. what’s your next goal? How fast do you want to go?

[@InnovationRC]

Warm up runs usually are less than 120 mph for me. I decided to punch it first time and surprised myself. If I go to a longer road I would appreciate 140 mph. I am not trying to get the fastest speeds out there 😉

[@notrcmaskedmaster4374]

Yeah I totally agree. Unless your planning on drag racing for money. Are you ? Lol. I don’t even know if that’s legal in the United Kingdom or America. Keep up what your doing. Who knows one day you could be in the desert trying to break the sound barrier with an RC lol ✌🏻😎🏴󠁧󠁢󠁷󠁬󠁳󠁿

[@intense_rcdevon7532]

What motor and esc are you using

[@InnovationRC]

Tp 2900kv

[@derjoh1986]

6s or 8s ??

[@InnovationRC]

6s

[@speedfreak1161]

Be Careful of those GRP's they will 💣💥. Nice Arrma

[@HJESR]

Luv it bro

[@mikeinvegas1]

Hi beautiful car! I want to build one like that. How much do i need to spend..car everything? A to z Thank u From las Vegas

[@MarcusHicksK.O.C]

Nice Pass

[@Yo0ne]

That a GREAT REFLEX STRONG THE RTR SO FAST SO GOOD SO STRONG and INNOVATION RC MERLIN MAGIK

[@rckiduk]

Super Fast 👍

[@xuanhungofficial6014]

Hello New friends, 73 like to meet you

[@chrisricotta7063]

I thought 84 mph on my 1/8 buggy was scary fast 😐😐

[@rcranch3838]

It is!

[@ianbudgetrc2574]

Damn that custom wing is whack! Im sure u can make that active by just attaching a servo

[@jake4194]

Why is it whack??

[@ominousnefarious5919]

Wow, not one time do you just show the car! Just pull back and frame the car so we can see it for what it is. With the body on. Maybe a side view, rear, front. W/e, anything other than nothing.