Neptune 4 Max remote controlled with wifi

[@Redhotandblue89]

Thank you for the video, it was extremely helpful. I wish Elegoo was as easy as Bambu Labs, but I'm thankful to you for your help.

[@918swimbikerun]

Can you make a video how to download klipper and use with Neptune 4 max? Or send a video to a video. I’m new to this and how to get klipper is confusing me ;( Your videos have been extremely helpful. Thank you. I have a Mac and don’t know what to do.

[@gubutek]

Neptune 4 Max comes with Klipper installed. You just need to go to the browser and go to your IP address.

[@918swimbikerun]

@@gubutek I put the ip address shown on the handheld interface but for some reason it does not appear or open in the web browser. Any other suggestions or recommendations?

[@918swimbikerun]

@@gubutek thank you I finally got it to work. Looks like the ip address was being blocked. Now to figure out how to use the slicer! Thank you again for your help

[@vision3dprint]

If printer is working with UPS and wifi connection is not in UPS , if there is power off does it affect printing

[@gubutek]

I don't have any experience with this but I did check from the 3d printing community. It seems like Klipper doesn't have the auto recovery function. So without UPS, power outage will be the end of the print. The UPS will save your printer but not so long (depends on its capacity). If printer is working with UPS, lost wifi connection will not affect it since the Gcode is already uploaded to the Klipper controller.

[@vision3dprint]

If there is power loss will the print recover , does power loss recovery works

[@michaelmann5732]

It does. However if the bed cools down, the print will break loose from the bed. It’s best to have the printer on a battery back up.

[@tierliebe-mit-handicap]

Is Firmware update via Wifi possible?

[@gubutek]

I don't know. Let me know if you figure it out.

[@Daniel-vh9lg]

Wow, your bed is way off! Definitely in need of manual adjustment.