New Controls on the Benelli TNT 135

[@ratchfordgeorge]

Taking the backfinder off is a bad idea you'll get a lot of spray on your back from wet roads plus, it looks very good on.

[@李春国-m8x]

Italian job. Ben tnt 135 = Ducati mini fun bike. Sexy exhaust + water pipe skeleton. Better choice ! 😀😆🤣

[@KrakensGarageandAdventures]

Good stuff @lexdfox, I have yet to address the bars on my TnT and this is on my wish list. Thanks for posting.

[@U.S.AVDUB89]

Did you have e to drill a hole in the for Throttle

[@tomasbonvehi3914]

I want to buy the fender eliminator bracket, You recommend that I add the micro led plate what offers MNNTHBX?

[@lexdfox]

Up to you, but I've found the brake light is close enough that it's illuminated.

[@acecobra01]

Did you cut any length off the end of the handlebars or left them full length?

[@lexdfox]

Kept them full length.

[@acecobra01]

Thank you!

[@Loopa.v]

please help I got the exact same bars have the exact same bike but my clutch and brake levers don't have enough slack in cables to fit the bars

[@lexdfox]

Hmm, I didn't have any clearance issues when I put the bars on, maybe they're underneath the wiring loom or something like that?

[@Stack-P]

@@lexdfox do i need to drill a hole in the bars for the controls?

[@lexdfox]

@@Stack-P Yeah, I believe there's one on each side. I wrapped the bar in painters tape, then fit the controls on where you want them and jiggle it a bit. When you take it off the tape will be torn where the hole needs to be drilled.

[@dylancurtis7557]

do you have a link to the pro taper handle bars? where you buy them?

[@lexdfox]

I got them from Drow Sports, a mini bike aftermarket part supplier in my area. www.drowsports.com/protaper-contour-handlebars-cr-high-1-1-8

[@frankrinker6011]

What size grips work for those bars?

[@lexdfox]

Any universal fit mx or motorcycle grip. They're fat bars but they taper down to standard size

[@frankrinker6011]

Thanks. Did you ever find something to work for the bar weights?

[@lexdfox]

@@frankrinker6011 yeah found some small bar ends from aliexpress

[@frankrinker6011]

Got the new bars on today. Looks good. What size bar ends should I look for?

[@MrZajfu]

Hi. Whats the original benelli handlebar inner diameter ?

[@lexdfox]

The benelli's handlebar is a 1 1/8in or 28.5mm, the bars I replaced were a direct fit to the stock clamps.

[@MrZajfu]

@@lexdfox thats the inner or outer diameter ?

[@lexdfox]

@@MrZajfu That's outer, inner I think is 16mm?

[@MrZajfu]

@@lexdfox Is the original bar exactly the same diameter as the one that you put it on ?

[@lexdfox]

@@MrZajfu inner? no. outer? yes. The new bar was a bit smaller inner diameter, maybe 13mm