New Genetry Solar Firmware Available

[@gravelydon7072]

My Gen 1 modified to Gen2 is sitting right at 115V on the inverter. House Voltage shows as 121V. Back when we had 90 customers on the single phase line out front, our power would range from as low as 95V up to 135V. Now that there are only 19 customers on the line, it stay pretty close to 120V all the time.

[@tootallsteve1]

Nice job boys!

[@solarandwindinsouthtexasda1473]

Mines is sitting on top of the table. I am waiting on some wires and terminals.

[@DavidHalko]

Yes, my inverter is sitting on top of a bunch of batteries! I keep ordering pieces to wire mine up, several terminals were a fraction of an inch off, upon reception, forcing me to either wait for new orders or adjust things. Still trying to figure out how to get reasonable strain reliefs & clamps working on my 12k A/C power cover, since the cover is a little small to fit standard wire clamps.

[@bobbyt3451]

ive had a 6000 watt inverter for about a couple years and its the best inverter ive seen or used

[@gravelydon7072]

@@bobbyt3451 Yeah, both of mine are passed the warranty periods.

[@dickson4650]

@@DavidHalko I do not use the GS12kw cover or strain reliefs and let the wires hang down like the Powerjack AC terminals .

[@DavidHalko]

@@dickson4650 - I did not feel comfortable powering it up, without the strain reliefs & protections from high voltage ⚡️ A/C…

[@paulpixzy5297]

In my country if acvolt reashes 245 volts the system should turn down else you watch every application burn/damage

[@sidlori1592]

The reason for the AC Input - Output voltage matching on the GS inverters, is so it can seamlessly switch to AC Input if desired. If there's a voltage difference, a "seamless transition" will result in undesired power flow. (This was happening with the 10v transition error--which the update solves.) Though it could be conceivable to put a "high limit" on the GS inverters' input qualification, making it drop back to battery if the AC input voltage exceeds a setpoint.

[@CarlosS-hk4fk]

I believe that update was temporarily pulled due to some inverters experiencing a minor issue with it.

[@sidlori1592]

That is correct.

[@stevehanely9446]

Was pulled before this video was released I believe

[@sidlori1592]

released as 1.2r5 with the issue fixed.

[@mikoserbousek4987]

@@sidlori1592 Thanks =)

[@bobbyt3451]

hopefully the new site is getting running ok but im still not getting a return password reset link so not able to get into forums

[@sidlori1592]

Uh oh. Lemme look into this shortly.

[@sidlori1592]

Have you checked your spam folder?

[@bobbyt3451]

@@sidlori1592 yes nothing there,maybe i should just rejoin ?

[@bobbyt3451]

@@sidlori1592 just now sent a new request for password reset

[@bobbyt3451]

@@sidlori1592 finally worked im back in thank you !