Nissan Micra K12 2004 auto Transmission fluid change

Рет қаралды 10,357

Күн бұрын

Пікірлер: 27

@onurkaraarslan1820 9 ай бұрын

The filling location is not clearly understood in the video. Are the filling values from the place where we measure the oil level?

@DaringBeefcake 9 ай бұрын

I don’t understand the question sorry, what do you mean by, are the filling values from the place where we measure the oil ?. Not sure what that means. But to clarify the filling amount I used, I measure the amount I drained and then refilled the same amount via the hole in the video.

@behramoz 4 ай бұрын

Hello. What brand of transmission oil do you recommend for K12 Micra? Should we use dexron 6 or dexron 3? How many liters of oil came out when you opened the plug?

@DaringBeefcake 4 ай бұрын

The manual recommends Dexron III, all the info is in the video mate, i don't remember all the details, pls watch the video.

@fix-my-device 4 ай бұрын

Hello, My wife have the same car it's a K12 of 2005, Automatic, a garage mecanicien, told me that you do not have to change the Oil of the automatic Gears for that model, I got recently an Oil leak (Low leak) when it's hot and stopped when it goes cold, I checked the main Oil it's still Ok, I'll change shortly the oil pan gasket, and also have a big acceleration noise when you reach the 50km/h, do you thing the Transmission Oil could be the cause? Thanks.

@DaringBeefcake 4 ай бұрын

are you saying the noise comes from the transmission at 50km/h ? how can you tell is from the transmission? it might be something else..

@fix-my-device 4 ай бұрын

@@DaringBeefcake Thanks, I didn't say that is coming from the transmission but it could be the cause, anyway I checked today the level of the transmission Oil and indeed the leak is from their not from the engine Oil, the level is in the middle between Low and OK, I parked the car, and I'll look for a Garage in Suburb of Paris to do the Purge of the Transmission Oil and replace the oil pan gasket as the leak is coming from their. Thankks again for your usefull video.

@DaringBeefcake 4 ай бұрын

@@fix-my-device oh ok that’s great, glad you still have some oil, yes get it fixed as soon as possible, in that case may be the noise is from a wheel bearing? Sorry i assumed you may have been referring to the transmission. I had a few noisy rear ones on nissan note.

@fix-my-device 4 ай бұрын

@@DaringBeefcakehey thanks for the advice, I have some doubt about the noise as I changed them about 3years about it was a different noise like (coin ) but this noise is like big acceleration, anyway when I'll come back from holidays Ill check with the garage and let you know thanks a lot

@DaringBeefcake 4 ай бұрын

@@fix-my-device oh that sounds like maybe the chain is stretched in the engine but I hope 🤞 not. Have a safe trip.

@darrenmicallef5186 10 ай бұрын

Is there ANY FILTER to change for the transmission?

@DaringBeefcake 10 ай бұрын

There might be but am not sure 🤔.

@iank7340 Жыл бұрын

i have a 2008 k12, when i start car from cold (in the morning). gear shifts are ok 1,2,3..then there is a delay 3rd to fourth. but when the car runs for a while it's fine 3rd to fourth. Is this normal?

@DaringBeefcake Жыл бұрын

I don’t think it’s normal to be honest, may be an oil change would help, and if not possibly in the long run it may need replacement or refurbishment

@iank7340 Жыл бұрын

Could it be the drop resistor 31037. It was recently replaced plus transmission and transmission fluid?

@ojomahjonahs Жыл бұрын

Name of gear oil used please

@umer6686 6 ай бұрын

its manual says the capacity of automatic fluid in nissan march k12 is 7.7Litres and you put 3.3 ??

@DaringBeefcake 6 ай бұрын

If it has 7.7 litres and 3.3 came out as in my case then 4.4 remains in the torque converter. Unless you have a serious leak then the oil is not going to disappear. Which means if I put 7.7 litres then I will have 12.1 litres in there, and that is too much

@umer6686 6 ай бұрын

@@DaringBeefcake it may need some research

@DaringBeefcake 6 ай бұрын

@@umer6686 I’ll let you do your research.

@muhammadidrees2776 6 ай бұрын

when you disassemble torture converter and fluid cooler lines then you need full amount. otherwise you just need the same quality you drained