This is a short clip showing normal clutch noise from new a dual disk clutch. More information and mods at: CarboniteCummins.com
Пікірлер: 15
@russ3842 жыл бұрын
Throughout bearing is a little on the louder side. I've got a sb dd on a 12' g56, just replaced the throughout bearing and idler bearing, new mid plate plastic bushings. Way quieter now, had about 50k on sb before new bearings and what not.
@jeremyfenix80782 жыл бұрын
Thats just the throw out bearing "warming up". The "rattle" is more clinky and is constant until its warm.
@amandadavis9726 Жыл бұрын
This rattle IS normal for a SB DD clutch. Your throwout bearing will warn you that it’s about to fail. You’ll hear a ticking noise that slows down when pressing the clutch as you’re rolling to a stop. I caught mine before it let go,…all it cost me was labor and a new bearing.
@jonowens38414 жыл бұрын
That's what mine sounds like..
@jonesfarm183611 ай бұрын
My nv5600 rattles like marbles rolling around with clutch out in neutral only when cold, quiets down some when warmed up. Never had a dual disc clutch but was told it’s normal
@iGIVEH2OPEАй бұрын
does this chattering sound mean a worn out throw out bearing? is this a sign of improper wear or premature failure? sure it’s a performance part but will it last 100k miles or more if I don’t race the car? I’m hearing this sound from a mk7 gti I’m about to purchase.
@MechInvent5 жыл бұрын
Wish I saw this before I tore my whole truck apart for the “bad throwout bearing”. It was a $1500 clutch, surprise.
@johnfiliatreau21305 жыл бұрын
So the clutch was bad? Or?
@tommyreed23223 жыл бұрын
Yeah me too 🤦♂️ just dropped my trans put in a new throw out bearing put it back together same exact noise, started googling and read that it was completely normal 🤦♂️
@iGIVEH2OPEАй бұрын
@@tommyreed2322 😢
@iGIVEH2OPEАй бұрын
it’s normal but does this chattering sound mean a wearing out of a throw out bearing? is this a sign of improper wear or premature failure? sure it’s a performance part but will it last 100k miles or more if I don’t race my car? I’m hearing this sound from a mk7 GTI Im about to purchase.
@jspat678 жыл бұрын
Heres what we experienced. Install of a reman ZF 6 into a 6.0L with a dual disc SB clutch. Rattling its ass off at an idle. Pulled trans. out and noticed throw out bearing had a metal housing. We slid the bearing into the fork where it rides. The play movement made a rattle noise and when we put a stock bearing with the plastic housing the clearance was less. We installed the stock bearing with the plastic housing and rattle disappeared. So many freaking problems with SB clutches. People thinking it's the transmission and it turns out to be those homemade, ground to worn out status, pieces of shite... Of course you call them and they know of no problems at all. Fuck those SB clutches. Look up a LUK set up. Single disc ceramic/organic.
@MechInvent5 жыл бұрын
jspat67 honestly I got the luk cause I ran outta money... it’s so so thin ... but lasted 60,000 miles so far. And I have pulled just about 300,000 lbs 60 miles with it. We also dropped it on install and broke one disk. Ps pedal is like three times easier to push.