O2 sensor delete 2006 CBR600rr

[@mirzasaj]

Very informative video thanks for sharing but i would use a heat shrink rather than using electric tape on that resistor

[@MikeyMlkey]

Would this work for a 06’ 1k? I installed a full toce exhaust system. Didn’t come with a O2 sensor plug, I plugged the hole with a nut they gave me. Installed a servo eliminator for that red plug. But should I do this to the white plug connection? The ecu was also sent to Toce for them to flash tune it.

[@moreclips805]

Only if your mil lamp is on

[@briann517]

What fairings are those I really want them

[@moreclips805]

Looks like theyre on sale right now www.nt-fairing.com/products/nt-fairing-injection-fairing-kit-fit-for-honda-cbr600rr-2005-2006-n110

[@BlackJoynt]

Hey, any idea why the bike idle soundslike that? Mine idles just like that and i’m trying to find out why

[@Rebourn365]

Try adjusting the idle screw on the left side of your bike. It's down by your stator. It's like an 8 point star dial looking thing. Middle will be Phillips screw. Twist it right until it's closed (don't force it or you could damage it). Start the bike and begin to twist it left until idle sounds better. If it's not that, check your fuel maps if you're running a power commander.

[@carlosloza7297]

Which slots/wires on the sensor did you jump?

[@moreclips805]

When you unplug the o2 sensor there will be a notch that secures the clip. Face that pointy notch upward and jump the two bottom terminals. Don’t remember the colors it’s been a while. Hope this helps!

[@moreclips805]

kzbin.info/www/bejne/Z5u2fI18rb17j6c this guy does a good job at explaining