OCCRE "Flying Dutchman"

This video features the Numbering and Cutting out of all the pieces of the Keel and Bulkheads. If you would like more information on this kit, here is the link:
occre.com/en-u...

[@MrCarsdude]

looks intresting.

[@tpbulle]

Looks like a beautiful and very challenging kit, Halloween - maybe, but, I'm in for the journey at any rate. This is a nice pick and I'm excited to watch the build!

[@TrekFanNCC-1701]

Thank you very much. Going to be fun for sure!

[@NikkiKuehnemund]

Finally, The Flying Dutchman😊 Not to rain on your parade, but you will not finish this by Halloween unless you don't have a job or something 😊 These models take a long time to build. Just a heads up, when you stain the ribs, the numbers you wrote on will dissappear.. You should mark the ribs with tape or something afterwards so you don't mix them up when they are stained. Check everything twice and make sure that everything is square to the keel. It will save you from a lot of trouble down the line:) Other than that, good start:) I'll be watching this like a hawk:) Good luck, Jerry:) This is just to help you, not criticism:)

[@michaelwild888]

I purchased this kit when it came out, but I have not found the time to start it. But you are getting excited to try it. Thanks for doing this...just saw this video so I will catch up watching them.

[@TrekFanNCC-1701]

My pleasure. Thank you for watching! I am very new to this type of modeling so no doubt my videos will contain errors. =-D

[@wildsau1965]

ive got the same kit but building three other ships right now . if i may suggest , you should sand the pieces first before you use the tint o r dye on them