Oil sensor repair - Optimax 115

[@nicktravascio8337]

Two years later and still works perfectly. I’m glad a lot of people have been helped by this video.

[@terrymorgan-v9p]

good idea! been fighting issue with 2007 optimax 90, and the tip about not using power blade was clever.

[@magnusr6473]

Nice fix 👌 Just curious, could you unplug the sensor and just trip the wire and use the motor without the oil level sensor? Just keeping an eye on the level every now and then.

[@tracyhenry2221]

Thanks for making this video bud! I’m about to make that cut 1” to the left 👍

[@nicktravascio8337]

You bet!

[@whackemwilly1498]

Also was yours beeping at like 2k rpm? That's what mine is doing. And it almost like kicks my motor into neutral

[@tracyhenry2221]

@@whackemwilly1498 it goes into limp mode after a while of running

[@whackemwilly1498]

Do you have any pictures of the you putting the new magnet on the sensor? Do you put it on top of the black thing inside? With some better adhesive?

[@nicktravascio8337]

@@whackemwilly1498Sorry for the 9 mo late response but yes I put it on top so it will stay put.

[@codyward265]

Have you had anymore issues with this since the fix? I was going to use epoxy?!?

[@nicktravascio8337]

By the way, I found I needed to be about an inch to the left of my initial cutout.

[@19bXb62]

I always get my plastic "red-hot" when I weld it . . .