Outlaw 11.5 Mods & Accessories

[@tresveinte5260]

It fits a 35 liter ice chest, and it sits in the far rear part of the kayak not under the seat.

[@kylemarvin2816]

Awesome set up!! I just bought a Perception Outlaw today and can’t wait to upgrade it!

[@davidmanevich1040]

Nice setup. I have a very large drybox that I keep under my outlaw seat. I can keep all my electronics dry and within easy reach. I've never had a problem with not having enough storage space on the outlaw. My next mod is going to be my trolling motor. Thanks for this video I got some good ideas

[@patrickt1087]

Nice setup! I ran across your video searching for mods to the Outlaw 11.5. I just bought one yesterday. I am already adding some of the mods you have done. I am adding an anchor trolley system too. Thanks for the video and ideas!!

[@davidmanevich1040]

You can get the 1" and the 1 1/2" screw ball mounts at amazon they were cheaper than perception for slot of the eccessories.

[@dixee6498]

Nice clean setup. Subscribed. Tight lines to you my friend.

[@MasChanclasAdventures]

thanks....appreciate it.

[@tresveinte5260]

wrap the reflective tape and then slip some clear heat shrink tube over it and heat it to shrink it down.

[@daliaguevara3612]

Appreciate your video. Would love to see what you end up doing as far as the trolling motor goes.

[@iKostanCom]

An awesome setup.

[@kccooks3821]

Nice review dude thanks

[@mybrotherskeeper111]

Great video, lots of great ideas. I’m really leaning towards the outlaw. Thank you!

[@davidmanevich1040]

Damn I should've waited till the end to comment. I love your bait bucket great job. I used to put my round buckets in milk crates for stability, but I like your square bucket answer better. You should try to get a patend for it. I'm sure they would sell... Good luck I'd buy one but after seeing it I'll probably build one this winter. I've got a feeling I'll be spending alot of time in my garage with my yaks this winter doing multiple mods LOL. Trolling motor next.

[@kevintheis5636]

I’m also in SA and just bought the same Outlaw from Academy. I live pretty close to Woodlawn, let me know if you want to get another Outlaw out there with you sometime 🤙🏼

[@MasChanclasAdventures]

Hey Kevin....Woodlawn Lake is a great place to test out the yak but I would not fish there. If I am going to fish in town....I would probably go to Elmendorf Lake...the one by Our Lady of the Lake University. I might hold some bass...I've seen some people fish on yaks there. I mostly fish the bays in Corpus....which I am going this Wed. Taking a few days off and I am gonna camp at Bird Island Basin and fish for a few days on the yak.

[@marlind.odermatt8108]

@@MasChanclasAdventures Thanks for the tips, I live outside of SA and just bought the same kayak. I am excited to do some fishing from it b/c usually I hit the rivers and it can be a little too fast pace to do any fishing.

[@stevehildre9073]

Nice set up! Any idea what the white circular plastic pieced is that is under the seat in the middle of the kayak? Is that mean to be removed??

[@MasChanclasAdventures]

Thanks Steve....... I think it's either used as an extra scupper hole or maybe something to do with running electronics thru the hull. That's just a guess tho.

[@user-bx3zz9cx3y]

It’s part of the molding process. It’s a permanent part of the kayak and serves no purpose other than in the construction.

[@robhand3255]

Hey, love the video, just purchase the Outlaw last week, where did u buy the metal loops that go on track ?? Love that idea fro tethering gear!! Thanks

[@sadiamond7]

I actually bought them for my Tacoma truck but I had a few left over and found a good use for them on the yak....here's the link: www.amazon.com/gp/product/B081JGR9Z5/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1

[@robhand3255]

@@sadiamond7 thank you sir

[@dustinmccumber8427]

Great set up. What paddle did you get that works well with the higher seat?

[@MasChanclasAdventures]

Thanks Dustin. I got the Magellan Outdoors HT Bent Carbon paddle. The 2 main reasons I picked that one was because first....I needed a long one due to the high seat...this one is 90" or so. And I needed one that was light since I don't have a trolling motor as of yet I will be doing a lot of paddling. And I won't get tired as fast as if I had a heavier one. One of the best advise I got was that if you are into kayaking...you will be switching to different kayaks every year or so...to find one that fits you...but get the very best paddle you can get because you can always use it on any kayak you get. I know it's a bit pricey (at least to me)...I paid $160 but it is well worth it. That's just my opinion.

[@dustinmccumber8427]

Awesome. Thank you for the details and suggestions. Very helpful.

[@cumbiaslopez4470]

Do you use a Dolly to pull your kayak? Does it have scupper holes on the back of kayak for cart?

[@MasChanclasAdventures]

I do not use a dolly. Since I yak on the bay side....I try to park as close to the water as I can and drag it the rest of the way. As long as the ground is not rocks...I am good. And yes...it does have scupper holes so you can make a cart out of PVC and wheels...that will work.

[@BarrettBivensFishing]

where you get that crate for tackle cases in it?

[@MasChanclasAdventures]

I got mine on Amazon a few years ago.... www.amazon.com/gp/product/B07GC7MDMV/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&th=1

[@jlansdale536]

How is it on windy days. I see in all these set up they have no anchor trolley system

[@KayakKingdom]

link to the Tacoma tie downs?

[@MasChanclasAdventures]

Here ya go........ www.amazon.com/gp/product/B081JGR9Z5/ref=ppx_yo_dt_b_asin_title_o05_s01?ie=UTF8&psc=1

[@stephencarter8045]

What storage in the middle is that and how did you do that

[@sadiamond7]

If you are referring to the black hatch....here is a link to it. It's a 5" inch as that's what fits perfectly. This 5" hatch is hard to find and is a bit pricey. But I have seen others but a 6" hatch and make it work. They are a bit cheaper. I got 2 of them....one for the front of the seat...so I can put my phone...wallet...keys...stuff like that. As it's water proof. And the other one I am going to install in the back so I can have access to the inside....as I plan to add either a trolling motor or a power pole. Probably the power pole. I haven't installed the hatch yet. www.amazon.com/Harmony-8023046-5-Inch-Hatch-Kit/dp/B0045NXEQA/ref=sr_1_5?dchild=1&keywords=kayak+hatch+5&qid=1614348079&sr=8-5

[@danielgreene5621]

I just purchased this kayak for my son. Could you tell me the size of the hatch and brand, please?

[@danielgreene5621]

The hatch you cut and put in the floor.

[@coreytaylor4202]

It's a 5in harmony hatch you'll need

[@MasChanclasAdventures]

I have seen other people put a 6in hatch...which is cheaper then a 5in for some strange reason. Tho the 5in I bought comes with a waterproof bag.

[@MrSweetloustyles]

I installed a 6” in the back and a 5” at your feet.

[@jakejoling6425]

Do you know what the dimensions are for the transducer "compartment"?

[@outquick]

I think the seat has 2 settings, are you on the lowest setting?

[@MasChanclasAdventures]

It only has one setting. Now you can take it off, fold it and place it in the back....as there is a place to store it. And in it's place....you can place a ice cooler....32/36 qrt cooler will fit.

[@manbunfishing1249]

I love this kayak! Check out this alternative to the overly expensive perception saddle bags! kzbin.info/www/bejne/npTJdKGkZdFsbNk

[@tresveinte5260]

Chingao vato. Use the proper tools to do the job.