P012B Turbo Boost Pressure Sensor. Lost Power On A Nissan Np300 While Driving

Losing engine power while accelerating on a Nissan Np300. Customer states that their pickup lost all throttle response when they made an attempt to drive it. Let's see if we can diagnose this issue.
#djmobileautoservices #mobilemechanics #diagnosedaniel #vehiclediagnostics #carlovers #vehiclediagnostics #diesel #dieselpower #nissan #trinimechanics
DISCLAIMER!! This video isn't for the unexperienced techs, DJ Mobile will not be held responsible for anyone using this material. No copyright video or audio is use in this video. All the copyright belongs to DJ MOBILE AUTO SERVICES.
At DJ Mobile Auto Services, we are here to assist you with automotive repairs and give you an insight on how we diagnose vehicles. We upload troubleshooting methods to diagnose vehicles that comes our way.

[@ryanventura5216]

Do you have a video on how to clean the sensor?thanks

[@djmobileauto]

No, sorry

[@TrevAutoTech]

Nice work!....as usual. I bet most guys would've replaced the sensor without even looking at it. I like how thorough you are .... I am the same way

[@djmobileauto]

Appreciate the comments bro.

[@DuaneDonaldson]

Thanks for the repair on this code by cleaning the sensor but where is the oil leak coming from, all of that needs to also be cleaned and ask the customer to stop back next week and probably again in the future so you can monitor that leak from the hose coupling at the cooler or the cooler itself is leaking and why is there so much blowby, cheers.

[@djmobileauto]

👍

[@dickydk01]

Hai sir im from malaysia.😮Manual car sir?i saw you vedio, Why rpm at 3000 only when you press the acceleration (gas). But when running car rpm normal over then 3000rpm. Then when car not running, paking (idle) and press the acceleration (gas) rpm 3000 only. Why, how to slove?

[@djmobileauto]

When driving the vehicle wasn't allowed to cross 3000 rpm, also in park. I cleaned the intercooler pressure sensor and was able to get the vehicle to respond again. I cleaned it with some electrical spray.

[@dickydk01]

@@djmobileauto thanks advice sir👍

[@Biang-t3x]

I have same problem how doni need to fix

[@djmobileauto]

Hi sorry for the delay. Not sure what you asking. Are you asking for my assistance or just stating something

[@ADDAUTOMOBILESERVICES]

👍

[@GabrielArturoGG]

Tengo el mismo problema, como lo solucionaron ?

[@djmobileauto]

I hope you get through. let us know if you do and what you did

[@carlosarocha7840]

Have the same Problem how did you solve it

[@boxz1984]

Where is the sensor located.

[@djmobileauto]

Behind the front bumper

[@boxz1984]

@@djmobileauto ok. I dont have it there. My sensor was in the intake manifold. 2016 twin turbo 190 hp i have

[@janncanlas502]

Had the same issue on my 2018 Navara. Replaced the sensor and everything went well until I drove it again. Car went in to limp mode and showing the same code. Any other sensor or item to check? 😢

[@djmobileauto]

Check the Mass air flow sensor, air filter condition, vacuum leaks or damaged intercooler.wiring connection to that sensor

[@janncanlas502]

Maf sensor cleaned, air filter is new as well then no weird sounds indicating vacuum leak. Would EGR and intake manifold cleaning help solve this?

[@djmobileauto]

Not sure. You may have to get it checked

[@aaronmubaiwa7662]

Where is it located

[@djmobileauto]

I believe I mentioned it in the video.