PelPro PP60/PP60-B/PP70/PPC90/PP130/PP130-B Control Board Replacement

[@NovaDan78]

Had a power outage a couple nights ago. Power was restored after 4 hours or so but was off and on for 2 minutes. My stove is on a surge protector. Fuse was good, found the snap switch or whatever it's called, reset it and stove seems to be ok so far.

[@mainstreamnashville3507]

I had the same issue was just coming here to post check the snap reset at the top of the auger!. I pulled the two wires off poked the button and everything started working again 🙃

[@user-rx6dz8ds7d]

Where is the snap switch located..I appreciate it..if you can tell me .

[@NovaDan78]

@user-rx6dz8ds7d it's hard to see it. If you take the right hand side panel off, you will see a little button/switch on the tube where the auger sits in

[@user-rx6dz8ds7d]

@@NovaDan78 thank you✊🏽✊🏽🙂

[@NovaDan78]

@user-rx6dz8ds7d no problem. Also just a word of advice, burn higher end pellets and you'll have no problem. I've been using Lignetics and it heats really well and hasn't jammed or anything. I know they cost more but you'll save yourself some headaches

[@Kate-ot7ck]

The light on my pelpro won’t turn on after being plugged in and it isn’t the outlet. Would the motherboard be the issue?

[@st8n8tive]

I’m having the same problem …left home came back and no light blinking…I called pelpro…test disk button…Nothing…..check fuse on control board….Nothing…so they offered me a new control board with warranty…

[@jeremymatheny6095]

My pp130 actually died this weekend as well, only owned for a week. Turned itself off after running for about 4 hours. No lights, no power in unit. checked fuse, snap disc. Called pelpro and also sending me a new control board today

[@Kate-ot7ck]

@@st8n8tive this is good to know! I’ll give them a call. I just bought a house and it came with so it would be great if it were under warranty. Thanks

[@Kate-ot7ck]

@@jeremymatheny6095 that’s What happened to mine. I’ll call to check, thanks!

[@st8n8tive]

@@jeremymatheny6095 I had mine for less than a month…purchase with Tractor supply…they offered me to exchange if I needed to. Considering it …but I finally got the smell off this unit

[@heatherl8454]

Does anything else need to be reset once it's replaced?

[@pelprostoves6142]

Hi Heather, once the control board is replaced there is nothing else that needs to be reset.

[@josephmartino9858]

My igniter doesn’t have power to it. I bought another one put it in no change. Will not light. What could it be. Please help.

[@Tractorman-qx8yr]

I have one word for Pelpro products JUNK ! They will not send warranty parts.

[@RLoose9494]

Circuit board $433.00 china built cost $1.00 sell to US sucker for 400% more

[@Texasracergal]

Italy Boards actually.

[@harrymarv1234]

ALL THESE COMMENTS REGARDING A PELLPRO STOVE THAT SGIT THE BED ALMOST IMMEDIATELY AND THE MANUFACTURERS SOLUTION IS SENDING YOU NEW PARTS LOL DOES THIS SOUND LIKE A SOUND PRODUCT TO YOU?!?!?! DOES THIS LOOK MO IKE A COMPETENT COMPANY TO YOU?!?!?!?!