This video is about PelPro Pellet Stove: Replacing the Auger Feed Motor
Пікірлер: 22
@brendarich73847 ай бұрын
Where can you get a new pin? Mine broke and the motor fell off. Also when I replaced the motor there was black grease on the old one. Should I be concerned about the grease?
@brendarich73847 ай бұрын
Also the Auger turns in opposite direction and switches disconnect.
@salemkid1979 Жыл бұрын
my auger motor doesnt detatch this easy, I pulled the pin out and its stuck like cement, any ideas?
@AsherKohler-ve3mw8 ай бұрын
Any luck on finding an answer to this?
@nlbrant7 ай бұрын
Rotate and tap the flat plate with a small hammer
@heidi2597 Жыл бұрын
I watched this/your video and it was extremely helpful. Any thoughts on this "new issue"? The stove will run and then all of a sudden the red light appears. Any thoughts?
@bammersmith59937 ай бұрын
I have a pelpro 130.You turn up the knob that has numbers on it it doesn't put more pellets in.Have any idea what it could be.
@johnsumner6185 Жыл бұрын
My auger motor is spinning to the point the cords are being disconnected and the vaccume wire was disconnected as well?????
@AsherKohler-ve3mw8 ай бұрын
I removed the pin but the motor won’t come out. What do I do?
@danielmcbride98222 жыл бұрын
Is it necessary to remove the entire system to replace the motor?
@SmittnKittn0072 жыл бұрын
We replaced to motor but nothing is moving. Could there be something else wrong that wouldn’t allow the Auger to turn?
@TheDirtyspice Жыл бұрын
@@SmittnKittn007 yep its your hopper lid switch wire or vacuum switch. Super easy fix
@masterlordking Жыл бұрын
auger quit turning last night ,try to remove auger motor pull the pin but motor will not drop,, am I missing something
@justincochran8933 Жыл бұрын
Sometime ya gotta tap it off esp if it’s sheared a pin.
@AsherKohler-ve3mw8 ай бұрын
Any luck on finding an answer to this?
@masterlordking8 ай бұрын
Yes pulled the pin and just had to tapped it off .just build up on the shaft
@AsherKohler-ve3mw8 ай бұрын
Thank you, still no luck here. I’ve been trying for some time. Don’t want to tap it too hard. I have a pelpro 60B. Do the pin holes need to be lined up? Or it should remove at any position?
@masterlordking8 ай бұрын
@@AsherKohler-ve3mw no they do not have to be lined up hold it with one hand tap it it’ll come off apparently you just not tap in hard enough
@Infamouscoma8856 ай бұрын
How do I stop a pelpro pp60 auger motor from turning and wrapping its wires around itself and unplugging? It will randomly do it and I don’t know why or how to stop it it’s set how it’s supposed to be
@masterlordking8 ай бұрын
Sounds like it’s jammed .. follow the video and do exactly like he says pull the pin. If the motor don’t come off, you’re gonna have to tap it off that’s what I had to do and then you can get everything.