Pentair Pool Bubbler and Pebble Sheen Repair

[@lawrencetisdall9850]

Can't THANK YOU Enough for this Video !! I had 3 bubblers about 3 inches higher than Baja shelf, I just contacted my Pool Builder Manager and told him this should be corrected like YOU did , I saw it before they plastered so I am praying this will be flush and level when finished . Again This video has helped SO Much Can't Thank You enough You did SUCH a great job explaining and showing how to do it right

[@BearsWorkshop]

Glad to have helped

[@Dadof5]

Thanks for the video on this!

[@musashimiyamoto4751]

pretty nice video man

[@BearsWorkshop]

Thanks Franky!

[@kathye.6513]

That is the bubbler we have, and the small cap that fits over the center of the top portion of the bubbler is missing. We have a new pool company who does not know how to replace that part. Do you know how we would get this? This is the first video I have found that has our exact bubbler, so hoping we can figure it out.

[@chachalu423]

how are the lights on the bubbler working out any issues I have heard they go out after a while... let me know thanks

[@mattayler2430]

Hello Bear! Any chance you have a video on how the "guts" of this light go together? We had ours installed, but it's not shooting up. It almost looks like the center plastic piece (looks like a donut) isn't installed in the center of the light. Any help is appreciated!

[@BearsWorkshop]

From what I have seen and experienced there must be an issue with the water flow from the pump. There should be a dedicated line from the pump to the light. Usually 3/4 pipe. A couple of questions. Has this every worked? Is this a new install? Do you know which valve on the pump controls the flow?

[@jeffreyjohnson9268]

you have to install the center round adapters, there will be two different sizes and they install from the top side, the hole has a notch they fit in to. One adapter is smaller for higher bubbles

[@paulmm07]

great video, how deep was your baja?

[@BearsWorkshop]

It is 10 inches. 12 would have been better.

[@richardcavanagh2908]

Who care about all the jargan just show the removal of the bubbler and how to.

[@martinceja4360]

Show how to repair it all i seen was u talking

[@BearsWorkshop]

The repair was done by the contractor. They removed the old fixtures which completely destroyed them. Then lowered the pipe feeding into it and then put the new fixtures in. Not an easy job.