Portable battery opperated 600W SoundSystem

[@MrSimondepro]

looks great can't wait for the next rave!!!

[@lloydcr1]

Do you use a crossover?

[@0youwannagethigh0]

Yes I do, the amp has low/high/all switch for each channel.

[@lloydcr1]

MethewsEmbeddedSystems cool, and do you split the output signal from the source?? Thanks

[@0youwannagethigh0]

Yep I do :). I split the stereo from the source. Each of the sides (right & left) goes to two channels, one with a high pass and one with a medium pass. Amplified signals go to right and left tweeters and mids. Than I also combine the two channels and and put them together in a fifth channe with a low pass, this channel than goes to the sub. I sill have a sixth channal left and want to combine the fifth and the sixth to double the power output to the sub. That would require a 180° phase shifter. But I haven't done that yet.

[@lloydcr1]

MethewsEmbeddedSystems thanks for the info. I want to build a 12v system too so your advice is very useful. I'm also looking at maybe using an active crossover before amplification to split high/low then send to two amps. looking for high efficiency. I want to test without spending too much dosh. Thanks again.