Priming a Nitro Engine

Quick video on priming an rc car's nitro engine.
Follow me on Twitter! @jn_lord
#!/jn_lord

[@hurstshiftin9873]

Just hold your finger or thumb over muffler and give it couple cranks works everytime.

[@alexandrossotiropoulos5621]

I thing the best way is to open the throttle fully and then pull the cord sometimes for the fuel to enter. Then you close the throttle to idle and start the engine. If you try to prime the engine with the throttle closed, the low needle goes inside injector and makes it difficult to start

[@zachcooper2759]

I just put my finger over the end of the exhaust and pull it over until the fuel gets to the high speed

[@ricardocamacho5721]

Zach Cooper You just saved my life 🙌🏻

[@NNNNNNNNNAE]

Oh my god after watching this I feel so stupid. Great video

[@yunnyenchong7107]

MaxamillionDuck iiiiiiiii

[@cooperwright736]

Same with a roto start engine?

[@TheInteligenceOvWar]

I took off the line and tried to blow the fuel up. It doesn't go up, what am I doing wrong?

[@gpix13]

@100randydmaster Check all connection from the fuel line to the nipple, make sure your gas tank is closed all the way, zip-tie your fuel lines to the nipples, if non of these work try replacing the fuel lines. -gpix13

[@markallen2020]

very helpfull

[@brandondarden9724]

What if I changed fuel lines and it still doesn't work?

[@planb3694]

good video thanks :)

[@gregoryosborn2466]

What what engine is that? I just bought a nitro truck no idea what I'm doing but its got a bunch of upgraded crap and eh $170 worth a shot

[@danelsanchez8985]

ima wanna try this method first before i try it the other way and that was giving it some gas using the controller and then starting it! lol.

[@darrylbuzick7451]

How should you break in ones of these motors properly. Video please

[@austin8728]

Slowly drive it in a circle