Procharged challenger new pb 1/4 mile on 93oct

Рет қаралды 714

MOPAR MUSCLE 304

Күн бұрын

Пікірлер: 13

@ramonbauza8461 Жыл бұрын

Damn that Corvette was flying

@moparmuscle304 Жыл бұрын

Yeah it ran like a 8.4 lol

@ShawnGilbert1967 10 ай бұрын

Sometimes with a tight stall, on a procharger if you spin a little it gets into boost quicker and higher ( like the stall is looser )...its threw me a loop too until i really looked at boost vs rpm vs time

@ErinLopez-ng9qh 5 ай бұрын

How can I get the most reliable power out of a hellcat 2023 I wanted to do a 2.75 upper 10 percent lower Want to be running over 800 wheel as a daily on pump gas Is it possible ?

@moparmuscle304 5 ай бұрын

a non red eye you can do a 2.85 upper with a 10%lower a jms boosta pump with fic 1000cc inj or if you plan to do e85 go with fic 1200cc injectors then of course tuning and youll need ngk 2309 spark plugs gapped at roughly .026 /.024 and you will need a pcm unlock and a bypass cable and hp tuners and do a mr gasket 180deg t stat part number 4367 .but that pulley combo on 93 on a other ys stock hellcat non red eye will make low 800 wheel thats bout the limit for 93 oct on a hellcat and bout as far as you want to push it with 93 . then you can retune it on e85 and make close to 900wheel on the same pulley combo you can drop to a 2.75 upper on e but you dont want to over spin the stock supercharger much harder than that unless you port it and upgrade the bearings

@ErinLopez-ng9qh 5 ай бұрын

@@moparmuscle304 why not go upper 2.75? Is it too much boost? Also can u run 17 rims without mods on rear end? Some say yes , some no Trying to run the biggest radial on the rear with smallest rim

@moparmuscle304 5 ай бұрын

@@ErinLopez-ng9qh low 800wheel is bout the limit for 93 pump gas on a hellcat with a stock blower unless you have some super efficient set up then it will make a little more if you push it to hard on 93 you can damage the pistons etc from detonation etc . and also on the 2.4 factory blower you do not want to over spin it for a long period of time you can damage the bearings in the blower . also harder you spin it the more heat it will make everything has a limit the 2.75 and smaller and with a 10% lower is starting to get to the limit for a stock 2.4 hc supercharger with factory bearings . like i have said on a stock hc with a 2.85 upper and 10% lower with a bap and inj / plugs and re tune on 93 youll be in the low 800 wheel range given the conditions and type of dyno last one i did made 830s to the wheels on are dyno at work on 93 ...... now switch to e85 on the same pulley combo and you will be close to 900wheel . ... and for the wheels and tires youll need the shorter rear sway bar links to fit 18/17 inch wheels you can run a 305/45/17 in the rear no prop . but 315/ 50 /17 on a regular body car non wide body depending the wheel spec and brand usually need a 1/4 plate spacer /and need to clearance the inner fender liner/ on the wide bodys they normally clear