Hello, how are you? My HelloRadio radio is not responding to voice commands. I have already set the "Power Switch to ON" on the HelloRadioSky Sensor screen. Any tips on how to solve this? My radio is an ELRS version. I appreciate any help.
@the-happy-RC-flyer23 күн бұрын
Hi Edwin, have you selected Voice LUA option next to the Power Switch option?
@gianantoniotoniolo85311 күн бұрын
Hello, my radio is in mode 2. How could I change the gimbals to mode 1? Thanks
@the-happy-RC-flyer3 күн бұрын
I was supplied a Mode 1 radio so have not completed the conversion. I have in the past swooped the gimbals over but this requires dismantling the radio. I have looked for a detailed manual that shows the adjustment screws to complete the conversion without dismantling the radio. I will look at producing a conversion video in the future if I can obtain this information.
@richardburrows1610Ай бұрын
Do you have an Opentx firmware and the sd card downloads for the jumper t16, preferably 2.3.15
@the-happy-RC-flyerАй бұрын
Hi Richard, go to the OpenTX website and you can still download the firmware and SDCard Contents. www.open-tx.org download and install Companion. If you need help take a look at my OpenTX playlist.
@edhipp62242 ай бұрын
my voice command for elevator is on my throttle trim .is there a fix?
@the-happy-RC-flyer2 ай бұрын
I think you are flying mode 2 throttle left gimbal. If you go to Radio setup check the radio’s mode it should show 2. If it is 1 this could be your problem.
@edhipp62242 ай бұрын
@@the-happy-RC-flyer no radio setup mode is mode 2( left=rud+thr) check yours and see.
@the-happy-RC-flyer2 ай бұрын
My radio is mode1 throttle right now.
@edhipp62242 ай бұрын
@@the-happy-RC-flyer I used cross trim to fix it. Voice needs a way to change trim or flap and gear in the voice to match.