Project CX-3 -- Genuine Mazda Arm Rest install Mazda CX-3 DK5 - G120 Revolution In this video: We install a Genuine Mazda CX-3 Arm Rest. powered by: east alps custom regards DRFT
Пікірлер: 21
@tim_sears4 жыл бұрын
I dont get why you had to remove the whole console if in the end you just put four holes in the back and screwed it on.
@K-carbon2 жыл бұрын
If you LOOKS at the instructions and video this guy is doing it correctly
@robdannatt5 жыл бұрын
Cool tutorial 😎 I've just bought the same arm rest for my car. Have you figured out what the dial at the bottom does / is for?
@mellisachristie96255 жыл бұрын
Is that applicable on mazda 2 skyactiv? Since both has the same center console i guess
@carbitch94985 жыл бұрын
Yes
@carloverdiary60893 жыл бұрын
i just want to see, how to remove the console box
@zQQm5 жыл бұрын
Tried to do with my autoCX-3 2017 but couldn't find how to lift of the whole console as it's connected with front vertical "wing" panels from each side and just could lift 2cm or so. Any ideas?
@569Sniper5 жыл бұрын
not sure what do you mean? you wanted to lift the center plastic with screen controler or someting else?
@squidy9325 жыл бұрын
I’m the same with u, remove half of ya console to fit an armrest
@shhhdontshout5 жыл бұрын
How much does it cost?
@gtrigga13 жыл бұрын
where did you buy that armrest?
@JMSsssssss4 жыл бұрын
Im trying to find information on replacing the rear center seatbelt for a 2014 mazda cx3. Is it possible? Looks like its built into the seat.
@charleslastname85872 жыл бұрын
Lmao should've showed what it looked like at the end
@JaimeHammett6 жыл бұрын
I dont really get the point why you dissasemble all the centre console, you only have to drill the 4 holes and install the metal thing, and then the armrest.
@eastalpscustom6 жыл бұрын
I installed the center armrest after instructions from Mazda.
@JaimeHammett6 жыл бұрын
@@eastalpscustom but the point is: do you really need to get off the centre console? If you had to do it again...would you dissasemble the center console or not?
@eastalpscustom6 жыл бұрын
For me it is easier to disassemble the center console to install the holder for the arm rest. I would disassemble the center console again if I had to install an armrest.
@TheBrewdonkey6 жыл бұрын
I've been wanting to get one of these for my wife's CX-3. What is your opinion about this arm rest? Everyone happy with it? Or does it feel cheap?
@zilch71165 жыл бұрын
TheBrewdonkey cheap and too high, they are flimsy and most of the aftermarket sucks