PROJECT MR2 : waterpump and timing belt install

so in this episode of the Mr2 project, i start on the engine and install the water pump and housing as well as the timing belt on my 4age!! this much closer to getting that 1.6 liter running
THE SOCIAL LINKS
FACEBOOK / joetheautoguy
TWITTER / joetheautoguy
GOOGLE+ plus.google.co...
BlOGGER joemakinmoney.b...
Email [e-mail]
Instagram / joetheautoguy
LIKE VIDEO GAMES CHECK OUT THIS GAMING CHANNEL
/ alucard9027
alucard9027
DISCLAIMER FOLLOWS
Due to factors beyond the control of JoeTheAutoGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. JoeTheAutoGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. JoeTheAutoGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of JoeTheAutoGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not JoeTheAutoGuy.

[@WoodLox]

Keep it alive,. Stock as possible,.

[@majorpain7248]

Great video ! What’s the torque for the cams and head cylinder ?

[@iLouieTube]

Great vid but you went in close for a shot on the timing belt kit code and it was blurry lol, please could i have the kit number please?, thanks.

[@bobwatson1132]

Just put timing belt on engine, the crank right up and seem to run good however when you put it in gear the engine do not have power to pull itself out of it's tracks. What is the problem

[@NavDexx]

Do you have to remove the timing belt to replace the water pump or can you get around it

[@awtsui]

Hey Joe, just in the process of doing this job on my 4age right now. Just wondering, did you add any additonal RTV/sealant around the water pump O-ring (where it connects to the block)? Mine is leaking, just want to make sure I don't have to do the whole job all over again. Thanks!

[@JoeTheAutoGuy]

No the gasket is the seal any additional will only disrupt the mating surface of the gasket to machined surfaces

[@awtsui]

@@JoeTheAutoGuy Thanks Joe, have a good one!

[@tylerbrune7525]

Hell yeah, about to do this with the motor still in the car and this helps a ton, thanks for the video Also what is the music playing in the background at the very end at 7:10? Sounds rad

[@spingebill5987]

3sgte swap it

[@JoeTheAutoGuy]

Spinge Bill more power is definetly the plan , bigger shop is plan first