Prop shaft at high speed in lathe

[@rayocaballo6122]

Master

[@pvtimberfaller]

I always use two hose clamps to retain keys when I am turning. Covering them with tape will reduce the entanglement hazard.

[@OgiveBC]

I usually just remove the key, this was just a very quick check with dial indicators turning over by hand, then that super spin so as to show customer it was in good shape.

[@hilltopmachineworks2131]

That will make you pucker a little.

[@StuartsShed]

Oof - has to be kind of wild to be stood next to that. 👍

[@OgiveBC]

Ya, not my idea of relaxing. Usually turn much slower, also usually take the duct tape and key off. Just a quick visual proof that the shaft was not the cause of the vibration reported.

[@WesleyHarcourtSTEAMandMORE]

200mph tape! Haha