Pulling the YJ motor and Update

My progress so far, pulling the motor and trans and new axles!
Music:
Rock Angel by Joakim Karud / joakimkarud
Creative Commons - Attribution-ShareAlike 3.0 Unported- CC BY-SA 3.0
creativecommons.org/licenses/b...
Music promoted by Audio Library • Video

[@mrslam49]

I just did motor swap on a 90 yj, a couple weeks ago. You can get rid of most of that wiring under the hood. A lot of it goes to the computer under the dash. I stripped all the wiring out and was only left with 4 main red wires that go to the starter/battery side, they feed power to the fuse block. The only other thing I left was one wire for temp sender, one wire for oil pressure, and the one wire for the heater blower motor. I ditched everything else. Open up that harness and strip all that shit out, it's not to hard.

[@mrslam49]

Also keep the oil pressure sending unit and the coolant temp sender, that's in the old 6 cylinder. You can adapt those to the chevy motor for use with your stock gauges in the jeep.. I dunno if you're keeping stock gauges, but I did, and it works great!

[@cmac956]

Sorry, Erocks Garage also does 3&4 Link's and diff's swaps.

[@cmac956]

The fellow from Erocks Garage has some good video's on engine swaps. He is a very good fabrocater ,check him out.