Rane FOUR | Adjusting the Crossfader Tension

[@Iamdprice]

How do you adjust the curve on the up faders ?

[@radientproductions9799]

Thank you , this is super easy!

[@roymoxley2587]

How about fixing the ground issues on these units Nothing but problems

[@gamingheadztvMediaHeadztv]

Are the line faders replaceable?

[@yoitsgiook]

Is this also possible with the channel faders? They have a lot of tension.

[@sabrecords5138]

Are the channel faders soldered to the motherboard? can they be easily replaced like a crossfader or not? what type of these channel potentiometers?

[@iamdjrichierich]

I dont understand how they think making the up and down faders so hard to deal with, they need to be as easy to get to as the crossfader! I have had my rane four 2 weeks and there is already shorts in the faders, they said try to reinstall the firmware and try it again, doubt that is going to fix it but that design is awful. Going to try the firmware update tonight.

[@cuttinchops]

It’s an inmusic thing I WISH THEY WOULD STOP DOING THIS SH!t! My NS7III had the same issues, sent it back under warranty and they BOTCHED the motherboard by “resoldering” with a fing HEAT GUN! You can even see the heat gun tip patterns of heat burnt on the board. If you can, fix it yourself or say F inmusic, sadly seems like they all solder the fader pots to the board, just sh!trier faders/soldering at inmusic.