Redcat volcano epx pro differential setup

[@EppeRRR]

I've seen your post on the HSP Facebook page, nice info voor a beginner like me 👍🏻

[@ragercrepair9301]

Not a problem man! Thays why I'm here.

[@williamhill9986]

Will that aluminum housing work with the shreeder if not, does one exist

[@ragercrepair9301]

No alumni um case exists yet. But with bearing upgrades and shimming the did they are great!

[@andystinson4668]

I have the plastic case but the grease is done. What grease replaces it? Redcat don't sell any according to tech support?

[@ragercrepair9301]

I just use any regular automotive grease.

[@TubsOnWheels101]

Where did you get the aluminum housing? It doesn't exist on the Redcat website.

[@ragercrepair9301]

It's discontinued now. You'll have to get it from Amazon or ebay.

[@TubsOnWheels101]

@@ragercrepair9301 thanks

[@daveat957]

Where you get the aluminum diff case?

[@ragercrepair9301]

You can get them off Amazon, ebay, right from redcat, or Ali express. Monkey hobby carries them but shipping is crazy expensive.

[@TheKylecrx]

I've just assembled this same diff for my Nitro HSP Sonic and have the opposite problem. The aluminum case is so tight the new differential assembly barely rotates. The bearings are seated properly in the case. Any suggestions?

[@ragercrepair9301]

I have had to take the shims out front behind the bearings on the diff and put it on the opposite side to adjust the mesh on some of the aluminum cases. If that doesn't work use some sand paper and sand where the outer bearing race sits against the case. That should help.

[@TheKylecrx]

@@ragercrepair9301 thanks, there's no shims anywhere so it looks like I'm removing material. Good video BTW 👍✌

[@ragercrepair9301]

@@TheKylecrx thanks bro. I try to be informative.

[@brandon130022]

Do you just use M2 machine screws to plug the 4 little holes on the rear? I have seen some stock models looks like some little cover or rubber plug that covers those?

[@ragercrepair9301]

No I just left mine open. There was no hole all the way through on mine, they had just the end of the holes threaded. It's for a sway bar link kit.

[@Overland_RC]

I don't need to shim plastic diff cases right?

[@ragercrepair9301]

You may need to if you are replacing the diff. I would always check and have shims on hand just in case.

[@Wardanyo]

THANK YOU!

[@ragercrepair9301]

You're welcome

[@ganglandlandlord9870]

Mine came new with no play ig I got lucky

[@ragercrepair9301]

I'd say

[@pattytimberlake5507]

Redcat drift car