Reflowing a old Dodge JTEC PCM to fix intermittent NO BUS message in Instrument Cluster.

If you're in need of service or assistance:
-ECU Repair Services: keyworks.us
-DIY/Pro Resources: autoelectronic...
You can also support our channel by using our affiliate links below (also found in our comment replies), where we may receive compensation for your purchases:
-eBay : keyworks.us/ln...
-Amazon : keyworks.us/ln...
-AliExpress : keyworks.us/ln...
If you'd like to make a direct contribution, you can do so via:
-Cash App: cash.app/$ecur...
-PayPal: paypal.me/keyw...
Your support means a lot to us, Thanks for watching!

[@nemesis1588]

the potting compound they used in these is just wonderful isnt it? 🤣

[@williamlackey7]

Can you fix mine

[@BaxleyBuildz]

Can't get the mother board out of the casing. I done heated it up and everything. Can't get it out...

[@ecurepair]

yea they are a pita. I usually bake it on a preheater for awhile at 200C. After that it usually comes out ok. I like to use a painters tool to get underneath it and help lift it up. Just gotta be super careful and slow steady pressure.

[@BaxleyBuildz]

@@ecurepair I tried baking at 250⁰f for 39 min and no budge. I took and knife and cut around edges etc. I can't find any other videos on how to do it.

[@Garyandterry]

@@BaxleyBuildzhad to do mine and just got it out at 160 for like 45 mins and was tough..that’s after trying it at 150 for longer with no success

[@davedorsette]

Hey brother great video I'm considering doing this I've reflowed PlayStations and Xboxes in the past I'm guessing this is pretty similar what's the success rate on this and how long does a successful reflow usually last. Thanks