Reloading your WRD Orange Bat QC

[@professionalautoglass2042]

🏆🎖️ Semper fi ✊🏻💪🏻

[@professionalautoglass2042]

What’s why , I following you, because you are the best

[@autoglass_help_line]

@@professionalautoglass2042 Not yet, but I’m working on it. 😁

[@rockstarwindowtinting]

Why two loops?

[@autoglass_help_line]

@@rockstarwindowtinting Before I tie the knot to hold the line?

[@gvQmusic]

What's the amount of cars you should be able to reach per cable load? I often have the problem that my cable snaps (due to pressure) on the orange bat itself. Most of the times this only shows up when doing the next car. Do you have any tips on this? If you my explanation isn't good enough, I'll try again 😀 Thanks!

[@autoglass_help_line]

@@gvQmusic I usually get about 6-8 cars per cable load. Let me ask this. Are you just using the U lock to stop the other spool or are you using a drag?

[@gvQmusic]

@@autoglass_help_line I average about 3-4 cars per line so there's improvement to be made. I don't use the u lock as a drag and usually use 3 positions for the bat. Top left corner (facing up), right side (facing side) and as last position top right (facing up).

[@autoglass_help_line]

@@gvQmusic I can usually get a windshield out in one move. From top left (about halfway between the pillar and the mirror) and then top right about the same position, both facing up. Check out one of my removal videos for better detail. If you don’t use the “u lock” how do you stop the opposite spool from spinning while using a drill or the hand crank to cut out?