Remove bumper and replace fogs - Honda Accord CW2 CU2

Remove bumper with park sensors and water head light nozzle spray from bumper to replace fogs lamps , behind the grill is the cruise active control. not a problem, does not need to be touched.
everything will be the same on the cu2 and cw2 , some might not have the water spray for the headlights or some might not have the pdc , park distance , that will make everything even easier.. good luck..

[@chynac8226]

This was soo helpful. I noticed that youre missing a piece of your grill/grille thats rite above the “H” emblem. This exact thing happened to me as i was driving, that piece of my grill/grille flew off on the highway. Now i have to replace the grill/grille so I’m happy to have found this video.

[@miscman10000]

Hello, what wheels have you installed

[@cassiem1148]

is it the same for the type s accord?

[@jenslakemeier5193]

Hello where did you find fog lights housing replacement

[@OnlineHousehusband]

Great helpful vid. I need to do this exact job. Just a question........It looked like you removed the lower grill? Why is this needed whilst changing the fogs?

[@oTToMoTioNMeDia]

Hi, i removed the lower grill just to respray it,could be possible to to just change the fog bulbs without removing the whole bumper, but to get the whole fog out, will have to be removed

[@OnlineHousehusband]

@@oTToMoTioNMeDia yeah all done now. It was a bumper off job. Not too bad of a job. 👍

[@urdead2meboy]

yea you dont need to undo the head light washer jets ..

[@shonniebhida]

Sir, i would like to replace the grill for a Russian 1 which has no `H`` on it, its currently all plastic Chrome, can i remove it without removing the whole bumper, if i try and remove the whole Bumper knowing me, i will scratch or damage something..can the top section Bumper, be pulled forward so i can reach down to remove the grill, will there be enoughf space for my hands?

[@oTToMoTioNMeDia]

Hi there, boy sure about other specs.. but on mine and most.. ull have to remove the bumper to remove grill... there's screws that are at the bottom of the grill

[@Lucky_Thirteen13]

I can't believe i need to remove a bumper to replace my blown headlights tbh

[@SBBUK]

Late reply but to do replace the bulb you don't need to remove the whole bumper. this is only to replace the whole light unit - from 2009 Acura TSX service manual (same car) - for right side, remove the splash shield (see page 20-214), for left side, remove the left inner fender (see page 20-213).