Thanks for sharing. Would not have been able to get carbs off without pry trick!
@Oktavian13374 жыл бұрын
same here! Just did it, seemed impossible to get the carbs off without the pry trick!
@masonreese91773 жыл бұрын
Thank u very much, this was extremely helpful
@Vintage.Mindset4 жыл бұрын
Great video, thank you.
@___Eldritch3 жыл бұрын
Just grab the carbs at the top and pull back. It puts even pressure on all of them and won't loosen the connection from bending them by only pulling one.
@charlesjohns30034 жыл бұрын
if you replace your hardened coller rubbers? which arent expensive, then apply a smear of sylicon grease to both the new rubber and alloy flange! the carbs will push on snug and not require any form of hammering!
@poloacosta22444 ай бұрын
Que pasa sino conectas esas 3 mangueras de arriba?
@alberthunt85013 жыл бұрын
What holes did u plug up since you dont have the vaccum system on it?
@theunchartedmap4 жыл бұрын
THANK YOU
@nicholasmartin2972 жыл бұрын
Is the jumbo screwdriver a Philips or regular flat head?
@hankrodriguezhill70295 жыл бұрын
Thank you so much for uploading this very detailed video, will get couple thousand views ,only complain ,plz consider upgrading Camara quality besides that it's great video.