Repair broken Fin Plug - FCS 1

[@ThouPablo]

Nice video :) I like the zip tie fix on the pencil too hahaha

[@kyragali]

Hey! Could you tell what is the distance between the two plugs, thanks!

[@cerritosway]

Hey Good question, I dont know!!! 😂 I always Used a Sample Fin to mark out the place.

[@guidoalejandrobelcic5163]

Hi, great video! How is the glue mixture that you use to insert the plug made of?

[@cerritosway]

Sorry for being late. Is epoxy resin + microsphere glass

[@hoveasy]

So 4 layers of 4oz under and one over?

[@cerritosway]

More or Less... It depens on how deep you sand, to recover the level. But usually with 2 layer and one over is fine.

[@hoveasy]

@ thanks

[@alexeygembik608]

Hi mate, I have same issue on my board and going to fix it myself (never done that before). Would you mind to advise what material did you use. Thanks.

[@cerritosway]

Just see It now, i was off KZbin for a while. Hope your fix went good!

[@smallkinedings]

Good man

[@felip3dable]

Hi! Did you use the router with some kind of guide? How do you keep the resin out from the plug slot and the screw when you applied the last cloth? did you cut the cloth over the slot with a knife?

[@ThouPablo]

not exactly sure how he did it, but just put some tape over the holes. And cut the cloth with scizzors