Replacing 2008-2012 Ford Escape Motor Mount. Lower Back Engine Mount 3.0L V6

[@tantran3469]

For anyone about to do this, you can also reach the 15 mm thru-bolt by removing the passenger side wheel well plastics and using a few socket extension rods. I did it this way because I wasn't able to jack the car up enough to fit underneath it.

[@juanantonionuila3529]

Muchas, gracias aprendi mucho canbiare, este soporte,de mi ford,2011 vien expicado, desde el salvador, soyapango, se le agradece, muchos exitos vendiciones,

[@romanmartinez5526]

Exelente, gracias a eso podré cambiarlo yo💪🏻

[@janghu1681]

good job , Tks you ..

[@chasezoeller875]

I’m trying to do this on an all wheel drive and I am probably going to have to drop the gear case. Which requires removal of h-frame…..

[@gegervary]

What did you end up doing? Just looking at it is vomit inducing, what a shitty design, at least if the slid the bold in from the other side where it’s more accessible 🤦‍♂️

[@kerrylewis2581]

Subscribed. Asked this same question. I own a 2009 V6 with 183,000. Vibration when stopped and slightly better when placed in neutral. Did all mounts need to be replaced to remove the problem?

[@philippe7431]

I recommended replacing all mounts. Especially if vibration stops when placing it in neutral

[@joemarrondon113]

What its the brand of that Mounts? I'm looking for a good replacement

[@kerrylewis2581]

@@joemarrondon113 I ended up going with OEM Ford. I have a friend who got me employee cost. It solved my vibration problem.

[@romulodonato8599]

Hello, do you know what size the back screw is?

[@philippe7431]

15mm I believe

[@douglasevans4525]

You were pushing not pulling