Replacing O-rings on a Render Recovery Bow Winch

[@SERESurfer]

Nice bucket spill! **it happens. Last spill we had was a CPP expansion joint let go!! 250 gals into the bilge...Fun night! I’ll take a drain bucket any day!

[@epicfred]

Thankfully it was only what was in the hose, not my worst spill.

[@shadowbanned69]

As always ...good info bro

[@BruceBoschek]

Not having ever seen a render recovery winch I watched this three times to try to understand where the O-rings went. Enjoyed the discussion. Thanks.

[@epicfred]

I should have done a better job recording, it’s hard to judge what will look good on screen because of the wide angle lens on the GoPro, the camera was only a couple feet away and it still didn’t show what was going on very well. I’ll try to get the camera up closer to what I’m doing and break things down more to show what’s going on.

[@BruceBoschek]

@@epicfred Thanks, I appreciate the efforts you make. Since I have never even seen a winch like this it's not possible for you to figure out all of the details. I enjoy your general comments about O-rings in valve bodies, etc. People who work with these machines will understand much better.

[@Seemann17329]

2:41.... i felt that.