Replacing rotted 5/8" plywood corner pieces.

[@arockingroupie]

How do I know where to staple on the sides? Some of my boards fell off

[@sandiegodan]

I'm chasing a leak and will probably have to elevate the tub and remove the corners. It's a Hot Springs Tiger River, looks very much like this one. Any videos or good resources for lifting them and removing the outer corners? Thanks.

[@craigsmith5025]

First off, did it freeze? Is the leak infoam? Did you check the light lens, which seems like an infoam leak but is not?

[@sandiegodan]

@@craigsmith5025 Thanks for following up. San Diego so it’s not a freeze issue. I’ve eliminated everything in the main compartment which includes the light. I’ve drained the tub down to the top level of jets and it slowed quite a bit. Only the middle panels on each of the four sides of the spa removed with screws and I’ve been looking for videos that show how the corners would come off if I have to get in there. Also, since there is a lot of wet foam and it seems soaked through, I wanted to be prepared to raise the tub if I have to dig through the lower area. I’ve only found one video that actually details the process of jacking up and supporting the tub so looking for more options. How do you know how much support is enough? What’s the best way to get the initial lift to fit a jack underneath?