RP4 CH11 Canbus Controller Walk though

Most Vehicles today will require a Canbus Controller when installing a aftermarket Stereo for everything to work Properly.
RP4 CH11 Canbus Controller amzn.to/3bAGBAT
All-in-one radio replacement & steering wheel control interface; Preloaded with amp-retention & navigation-based output signals; Retains all important OEM safety & convenience features
Data-controlled RAP accessory output; Data-controlled outputs for connection to navigation radio & speed, reverse & E-brake status output wires; Keeps vehicle databus intact for service & emissions testing; Retains factory-installed amplified audio system; Interface can be quickly updated if needed from the PAC(R) website using PAC-UP USB adapter; For select Chrysler(R) vehicles with CANbus;
DISCLAIMER: Due to factors out of the control of Bullshitkorner and Bsk Garage, we cannot guarantee against improper use or unauthorized modifications of this information. Bullshitkorner and Bsk garage assumes no liability or responsibility for property damages or injury incurred as a result of any information contained in this video and all other videos produced by Bullshitkorner and Bsk Garage. Use this information at your own risk. Bullshitkorner and Bsk Garage recommends safe practices when working on vehicles and/or with tools seen in this video. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Bullshitkorner and Bsk Garage Be safe! This video and description contain affiliate links, which means that if you click on one of the product links, we receive a small commission. This helps support the channel and allows us to continue to make videos like this. Thank you for the support!
#Rp4ch11 #canbuscontroller #stereoinstall

[@franciscopedrera]

I need to install a radio on a 2008. - Nitro, do you have a video for that type of installation? Thank you.

[@ruimiguelsantos9270]

did you conect the key and 2 to the wires or does the module not need that and u plug the 3.5mm jack directly in the atoto ? bcs i dont have key 1 and 2 cables on my jeep wrangler and i am confused ...

[@ecole82]

Did you get it same situation

[@SteveLShannon]

So far very happy with the stereo.

[@caponyx]

im working on my jeep jk and i bought the harness for the plug that irectly connects to the stock radio. is that harness not needed anymore if im using the pac interface?

[@ooodang180]

I bought a radio and it came with one of these but I’m installing for a Lexus lol so I don’t need it. I was wondering what if was for.

[@MVARacing]

There is a selector 0-9 on the RP4-CH11 depending which brand of head unit you have. What did you use?

[@jarrettdown2475]

I just installed mine. Works with 7

[@kil-0976]

Can i connect my evo x subwoofer rockford directly to the new android canbus without the amp? i wanna use the built in amp in the android headunit is it possible?

[@bradsalinas6002]

I did the same installation and wiring but my auto-headlights stopped working. Do you have an idea of what might’ve gone wrong ?

[@meStevo]

I know anteanna isn't part of this great wiring harness explainer, but how does sat radio factor into a job like this? We've got an OEM radio replaced by Best Buy, looks like we need a SAT-01 connection, but not sure what it should be connecting to.

[@mrmegachingon]

Did this wiring worked as shown?

[@thumpy662]

Where does the blue with white stripe wire goes on the steering wheel aux plug?

[@EagleTheBirdman]

No. It will be a different plug in back of radio. If the brand radio dont have it, then you hook the blue wire up instead to steering wheel wire at back of radio. Usually a purple or orange wire. Not orange dimmer wire that's different

[@Justriggin]

Ok what's the radio select switch?

[@nicholassarrazine1717]

Hey I've had the little resistor board burn out. No power going through it what should I do

[@TestDontguess]

Buy a new one

[@nicholassarrazine1717]

@@TestDontguess can you get just that little resistor board?

[@danhambrick6331]

Looks like a bowl of spaghetti Jerry.😂😂

[@michaelbloom5342]

You are going to wind up despising that crap Chinesium stereo. They are buggy as hell, and just don't last.

[@TestDontguess]

Ran the same brand name in my truck for over 4 years before I sold it no issues, been about the same for the one in my TJ as well no problems 🤷🏻‍♂️