Run your Takeoff Calculation LIKE A PRO - Useful tips and tricks for Asobos new EFB TAKEOFF PERF

Join my channel!
/ @a330driver
If you don't want to join, but still support me consider a small donation:
www.buymeacoffee.com/737NGDriver
And if you really love the videos, consider becoming a Patron:
/ 737ngdriver
Join my Discord Server!
/ discord
My system specs:
Intel i9-9900k@5,2GHz
RTX3080Ti
32GB RAM
Windows 10 Pro
My hardware:
Thrustmaster Boeing Yoke
WinWings Orion2/F16 Grip
Thrustmaster Pendular Pedals
Honeycomb Bravo Throttle

[@jarekp4421]

Thank you very much for valuable info! Much appreciated

[@yeess2757]

Can you do the same tutorial for the PMDG 737 EFB on msfs? I don't know how to do it

[@danmoretti8898]

That's probably because the PMDG 737 does not yet have a publicly-released EFB.

[@ching28hk]

i wish we had an efb for pmdg 737 lol

[@A330Driver]

I surely will do that.

[@scottwiser]

It was worth a shot

[@flyingpedal]

Very good thanks You show very well how to alternate between EFB and FMS. You enter 35 as value for CG. Where you found it?

[@tomstravels520]

What is the climb schedule for the 787? Like the 737 where you keep flaps up speed until 3000ft AGL in NADP2?

[@tonymcflattie2450]

Wait, you guys are doing takeoff calculations?

[@AzizuddinAziz]

We just put them in TOGA and hope the plane will takeoff. Lol

[@zoe..d]

Holding F3 and bouncing it off the limiter... is certainly one technique. "Everybody is so creative"

[@dicko6833]

Hi Emanuel. Every time I complete CDU and EFB take off performance calculations the D-rate value in the CDU is always higher than in the EFB and you said these have to match but can differ point something. My values are way out and never match. Toga they match. I follow FCOM but every time the CDU d-rate does not match. Any ideas. Steve

[@antonbatura8385]

Have a problem with the 787, when I do everything as per this video, as soon as I hit "accept" takeoff data, the v speeds are not entered, and the cdu displays a message that v speeds are deleted due to change of takeoff parameters, and nothing that I do helps. I cannot enter them manually, I cannot click them in from the QRH, I cannot get the calculated data to load into the cdu. Every time I get the same message and the speeds remain unfilled. I've tried multiple times, no go. I sure hope this is just some silly mistake of mine that someone can point out.

[@maestro7332]

ATM below flat rated temperature? Does that make any sense?

[@A330Driver]

I've actually had takeoffs in the 737 with an ATM of 29 degrees at sea level while they're flat rated at ISA+15.

[@devansh8846]

Nice video. You might wanna fix your title Captain. It should be tips*.

[@A330Driver]

Good one, fixed