RV6 Performance Adjustable Rear Sway Bar Install Guide for 10th Generation Civic Type R FK8

[@Hind135]

Thanks for the tip on raising both wheels to get the end links to line up, I was bout to give up.

[@Allwayskind6]

Those metal sleeves on the endlinks don’t go into the hole on the sway bar? Looks weird that the end link has a gap between it and the sway bar..

[@jojo-cx4cn]

Is the large size too hard and loses comfort when driving? Which is better, between 19mm or 22mm ?. I'm a little scared when I want to use 22mm too big

[@wtam1100]

Good install video. You've had the RSB on there for some time now. I'm sure you been able to toss the car around to get a feel. How do you like the RV6 RSB compared to the other one that was in the video? Does the car oversteer too much on the stiffest setting?

[@wizkid22]

Great video, but endlink should be installed with the car on the ground with load on the car. When you install endlinks without load you are adding preload to bar which is not ideal

[@chriscrawford2197]

How do you get under the car to install the end links with it lowered?

[@reobressman]

Does your sway bar move side to side when cornering?

[@thinkforyourself5672]

Yes. It's pretty much a spring between your wheels.

[@langbamdoan]

Was it a Karcepts bar you that replaced with an RV6?

[@FuegoBoricua203]

Question is the rv6 sway bar noisy ? By chance

[@bshatto3111]

I have the whole rear suspension setup from RV6, so all I can say is I have an increase in noise from having solid suspension. That being said I don't think the noise is from the sway bar - I think as long as you have everything torqued correctly this part should not make any noise.