Schwinn OCC Chopper Stingray gets an 80cc engine Yep..these were lost videos

[@codebreakeractivate6366]

Congrats man you are never to old to do anything and thanks this video was amazing and now I'm getting the same kind of bike and kit

[@MaturePatriot]

I can see you tooling down the road on that chopper, leather jacket and chaps! LOL Nice work so far. That Hill Top Machine Works guy has a not bad idea! Waiting to see the final solution. 'Til next time.

[@flatheadronsgarage7345]

And bugs in my teeth. After I made the mount I found one on eBay and theirs is almost identical. Still need more tools 😁🤪🤪😇

[@KricSmith]

@@flatheadronsgarage7345 😂 same problem

[@gotchurebeacons-gaming9023]

I hate to spoil your great problem-solving solutions...but they make a bolt-on OCC mounting bracket provides the proper upright tubes at the proper angles at the proper off-set to line up with the rear sprocket. Also, for those who plan to build this great toy, they make lots of upgrade options for better rear sprocket mounting, exhaust, spring-loaded chain tensioner, etc. Less fabrication, better (and probably safer) setups and a longer life expectancy.

[@hilltopmachineworks2131]

Curious instead of moving the whole motor like your doing could you make a spud shaft to extend the sprocket out?

[@MaturePatriot]

Sometimes another set of eyes, brings new ideas! Good idea.

[@flatheadronsgarage7345]

Thanks for watching Tom. Gear cover has the clutch lever mounted on it and the shaft for the clutch goes inside the drive shaft. Good idea though.

[@hilltopmachineworks2131]

10-4.

[@m.kasper7646]

@@hilltopmachineworks2131 wth is he talking about? "Clutch & drive shaft?"

[@z_easybro8576]

They also make a jackshift kit that you can make that can extend it either way as well and they also sell tmwhat he made pretty much for like 40-60$

[@m.kasper7646]

Well, Wheres the finished product?!!!

[@UbayLanas]

Thanks for posting this video. I enjoyed and learned something in someway. I am wondering, where did you buy the 80cc engine? Thanks in advance. Cheers!

[@z_easybro8576]

You should have just used 1-1.25” pipe welded to u channels with u bolts holding the channel to the bottom frame

[@patrickroberts7847]

Did you just call a bolt a screw?

[@contractkilla6587]

👍👍👍👍👍👍☝️

[@louismascia9777]

how much was all of this

[@m.kasper7646]

Way too much!!! He couldve bought the part he made allot cheaper and easier, allot of unnecessary machine work if you ask me Lol! They actually sell those plates with two bars online.

[@corethathehippie3226]

$87.00 Free shipping on Ebay.

[@m.kasper7646]

@@corethathehippie3226 hahaha! Waaaaay too much!!! They're only 35bucks!!

[@m.kasper7646]

@@corethathehippie3226 "free shipping"?!!! Lol! For 87dollars they fucken better!!!

[@KricSmith]

It’s the thrill of making it lol

[@1sabbsfan]

Turn the music off

[@m.kasper7646]

Its not the only way you have to mount it! They sell plates with the two bars, you sir do allot of unnecessary work. Ive built 3 of these & it was painful to watch you go through all that you did.

[@MrRomeobig]

Lol I feel the same way.to be kid again