Secret Cigarette Lighter Switch

Today I made a secret cigarette lighter switch for my power antenna!

[@backyardbuilttrucks1]

We do this on our street rods but gut the lighter and use a 30 amp push pull switch. Looks like lighter but kills power to ignition and or fuel pump.

[@Str8kustomz]

Can you make a video on how it's done

[@backyardbuilttrucks1]

@@Str8kustomz I will this weekend.

[@Str8kustomz]

Just subscribed can't wait i will be turned in thanks brother👊👊

[@backyardbuilttrucks1]

@@Str8kustomz Thanks for the sub .

[@imhereoften9452]

@@backyardbuilttrucks1 did you delete the video? I can’t find it

[@TheHydrogen32]

So you connected one side to the antenna wire, then to continue the loop where it would go on the radio plug?

[@therealboofighter]

Cool idea

[@livingincolorado4652]

Nice video keep it up.

[@travcool1991]

I know you did this a while back but can you explain why you have to solder the wire to the core to the outer edge?

[@velocityperformance8574]

Since I removed the heat element I needed to put the wire in there to complete the circuit to use it as a switch.

[@travcool1991]

@@velocityperformance8574 that makes sense. And it doesn't pop out randomly

[@stefanorossetti8351]

Dear friend i have a celica st-i with manual clima..... i have to change the bulbs in the air command on the dash... i have seen there is a short blu cable in the rear of command and i need to disconnect it from the unit? How can i do it? Can you help me? Thank you! I write from italy!

[@velocityperformance8574]

Disconnect it from the heater control valve in the engine bay, flip the metal tab over and the cable will pop off. It then will pull right through the fire wall. There is also a cable on the left side for the hearted box that needs to be disconnected at the floor as well

[@stefanorossetti8351]

Velocity Performance thank you! Haven’t got a video? I haven’t much experience! However the blu cable is connect on the floor near the central tunnel... is it correct?

[@velocityperformance8574]

I took a quick video, I hope this helps. If you need anything else just let me know. kzbin.info/www/bejne/h57Fp59vf5uKpqc

[@reedrobb]

I’m going to work a fuel pump cut out switch into my Jeep. Thanks

[@epidemic818]

Is it a Corolla?

[@velocityperformance8574]

Samson Simpson this was on my ‘92 Celica

[@AGR96]

@@velocityperformance8574 theoretical question (but important to me): what if one would plug an unmodified cigarette lighter in there?

[@Z-Ack]

I would wire that switch to the push to start relay.. thatd be some james bond type shit there.. nobody would figure out how to start the car and wouldnt have to use any fob to start the shit, just to unlock it..