Shaping Surfboard [2 of 2] Concave, Rails

Shaping a shortboard for a kiter friend.
Surfboard dimensions are 5'6 x 18" x 2 1/8.
This Board was made for kite wave so has got a low entry rocker and less volume then a normal surfboard.
Unfornutately I do not have the Glassing part video.
I’ve been shaping since 2017, but I would not declare my self as an expert.
Everytime I put a surfboard I shaped into the water the exlamation it is always the same "GALLEGGIA" (it floats).-
Shaping Surfboard [1 of 2] Thickness, Rocker, Outline:
• Shaping Surfboard [1 o...
Relevant TAG:
#surfboard shaping, #diy surfboard, #eps

[@jameso8418]

Nice concave.

[@timbarnett3898]

I did enjoy that shaping build, thanks!

[@cerritosway]

Thanks to you Tim!

[@FernandoMoralesAfonso]

Buen trabajo.

[@RyderTweedie]

Love it

[@1969_toTheMoon]

Muy buen video y trabajo! Como sabes o como elijes que medidas usar en los Rails.. por ejemplo primero marcaste 1/8 and then 2 1/4... de donde sacas esas medidas? Muchas Gracias!!

[@foamhacker6396]

Looks great. You're using EPS foam, right? What grits of sand paper do you like to use to work your way from rough shaping to finishing?

[@cerritosway]

Yes its EPS. I start with 40 grit, and i keep It using It almost till the end. Then I skip to 60/80 for the finish touch. I notice that if i work slowly It works fine.

[@HRuss123]

Where did you get the side light from

[@cerritosway]

Sorry for late answer. The side light are 2 led strip per side, bought It from local electric shop.

[@adondavaloslara7981]

Todo un shaper como puedo entrar a tu Facebook gracias

[@cerritosway]

Look for Genova 72 Surfboard @cerritosway