Surfboard Shaping - Rails Mark and Bend

[@nocturnasurfboardtenerife5456]

Precioso trabajo, felicidades. Un saludo desde las islas canarias

[@rooneyfamily6377]

Nice work man

[@mrfelipehurtado]

Awesome

[@CarsonWilcox08]

How do you know where to put the lines for the rails

[@cerritosway]

Hi Carson. I use 3d shape software to print rail template and deduct Marks. But on This One i went with standard Mark wich where 2 and 4 inches on deck . On rail 1 1/4 and 1 1/2 from bottom.

[@CarsonWilcox08]

Ok Thanks!!

[@Frank-pj3ic]

@@cerritosway Hi Cerritos. One question : I have Demo Shape 3D and I Can't print rails and outline. Help me?

[@cerritosway]

HI FRank! Take a screen shot of rail section. Use Photoshop or similar to scale it in real size, then print it on A4 paper.

[@Thepedroportes]

What blank did you use for this specific board?

[@cerritosway]

Ola Pedro! I used a BLOCK Cut peace of EPS around 30kg

[@宇阳胡]

你这个是eps内芯，还是pu内芯

[@cerritosway]

EPS from block cut. Not sueprfused

[@mrfelipehurtado]

PLEASE MOR VIDEOS!!!

[@romuyou3697]

Too bad you don't explain where to place your landmarks and the apex!!! thank you for your video

[@cerritosway]

Thanks for your appreciation. What would you like to know exatcly? I will help you if I can.

[@romuyou3697]

@@cerritosway the video and great and congratulations for the work. I would like to see how to knock down the rails. how to draw the lines in order to cut the rails (angles)

[@cerritosway]

@@romuyou3697 Thanks for the time you spend to watch and comment. You would like to see a specific board size?!

[@romuyou3697]

@@cerritosway hi!!! No just a shortboad! see how to place the apex according to rails (boxy or other) and how to knock them down! see how to place the markers for cutting the rails. thank you for this work

[@cerritosway]

@@romuyou3697 For short board I use 2 and 4 inches on deck mark, going trough nose and tail I divided by half. On rail, starting from bottom, I usually mark it the bottom tuck at 0.4" (1cm) and the middle mark between 1" and 1" 3/8 (2.5cm and 3.5 cm). This second mark will determinate your boxy or knify rail. Is diffult to explain it on words I will try to make a video sooner.