Short clip of removing gear set and replaceing shifter pawl.
Пікірлер: 19
@gljazz6 жыл бұрын
Thank you Pop's! This little video help me with the orientation of the shifter pawl return spring. Mine broke and and the service manual did not show how it is installed originally. Thanks again, and I like the slide guitar in the tune.Cheers!
@fjv4184 жыл бұрын
Ok i see this is on the other side of the primary and what you did was go on the other side removed caps and other stuff then pulled out the pawl shifter. Hard to tell what you where doing at first. Then realized what it was. Looks easy but still not sure on what to do or if the primary is pulled out as well. For a seal too
@infoinsular4862Ай бұрын
I have a question. There it seems that they did not remove the primary, it can be changed without removing the primary I have that problem on my motorcycle, a 2012 dyna switchback
@Popson2wheelsАй бұрын
The primary and the inner primary were removed to access the shift lever. I hope this helps. I had a hard time understanding your question.
@rcanoli996 жыл бұрын
nice steady shot...a little info would've been nice ... year/kind of bike, etc. nice vid anyway thanks for posting!
@Popson2wheels6 жыл бұрын
2005 Harley Ultra Classic. splines on shift pawl were worn down. shift pawl and shift lever replaced. I couldn't find any info on removing the gears, so I thought I would post this to remove the black magic of working on a Harley. 60k miles on the bike, up to 93k now without any problems.
@jamesconn11042 жыл бұрын
I have a question if not allowed i apologize. I have a 91 flhs it is hard to shift, 57 k on the clock , tranny full & clean oil, i adjusted the clutch today, not much freeplay,primarylooks to be full primary chain looks to fine fine not loose . shift levers on linkage has slack maybe an inch, . id say sloppy. i see pawl adjustment vids . i need some advice !! Thank You any advice would be greatly appreciated Sir !!
@nicholascummings6803 Жыл бұрын
Did you have to remove inner primary bearing race?
@Popson2wheels Жыл бұрын
The inner primary was removed to have access to the lever on the shaft. I don't remember about the Bearing Race.
@billgonzales89782 ай бұрын
2004 dyna shift pawl installation/? please
@Popson2wheels2 ай бұрын
I didn't intend for this to be an instructional video. I just posted it to show the internals of a V-Twin transmission. I only work on my bike, so I don't have a video from other models. I just followed the instructions in my FSM for my bike.
@glenoneil30744 жыл бұрын
My '04 lowrider shifts up in gears but downshifts are horrible tearing it apart soon.could this be my issue ?
@Popson2wheels4 жыл бұрын
I had to replace mine due to the shift lever working loose and wearing the splines. I'm not sure if this is causing your problem.