Full service #shimanostella2019 #shimanoswreels #reelrepair #reelservice
Пікірлер: 26
@bringit31645 ай бұрын
Definitely something I can't do 😂😂😂.
@Roddreel5 ай бұрын
Just practice sir
@ShorrockPaul2 ай бұрын
just noticed you greased the anti reverse bearing (ARB) collar, that is a no no. no grease should be on the ARB it could cause the ARB to slip.
@Roddreel2 ай бұрын
if too much so far im doing this for more than 10 yrs no complain at all.Is how you put the amount of oil or grease.try to think two metal rubbing each other with no lubrication what will happen? thanks
@joshuabarrath7222Ай бұрын
Nope it doesn't,I also put grease on the ARB and also no complaints
@joshuabarrath7222Ай бұрын
Why do you speed it up???????
@ShorrockPaul10 ай бұрын
What are you using on those gears.. should be Shimano DG13 (SRG) gear grease.
@Roddreel10 ай бұрын
No I don’t use shimano grease anymore I use my own grease full synthetic but different viscosity
@Roddreel very interesting are you a chemist or engineer. Not everyone can mix their own greases.. very impressive! BTW. What is that little bearing spinnng tool you use. ?
@Roddreel10 ай бұрын
@@ShorrockPaul custom made bearing checker
@ShorrockPaul2 ай бұрын
what size screw driver is used for the screw behind the rubber plug to take the rear chrome guard off ?
@Roddreel2 ай бұрын
im not familiar with sizes but the smallest from craftsman as long as its long 3mm head
@shorejiggerchris33644 ай бұрын
What is the type of the screw which opens the small round screw on the line roler?And which screw for rotor nut please?
@Roddreel4 ай бұрын
.8 hex screw tool
@shorejiggerchris33644 ай бұрын
@@Roddreel and for rotor nut please?
@rob-pj5jy4 ай бұрын
What is the grease you are using?. And oil?.
@Roddreel4 ай бұрын
synthetic sir
@笑星大炮鎚5 ай бұрын
To me, the 2019 Stella is a product that cuts corners. It has lost the value of the previous Stella.
@ShorrockPaul2 ай бұрын
How do you determine how tight to tighten the main rotor nut ?
@Roddreel2 ай бұрын
there are 2 marks near the rotor.not too loose and not too tight.
@ShorrockPaul2 ай бұрын
@@Roddreel Are you talking about those two little dimples cast in the rotor and what would you line up to them? reason am asking i took mine off and didnt notice or mark the nut so wondering how to position it. the cover for the nut is toothed so to an extent that also determines where the nut lays for the cover to line up with the three screw holes. Also i notice when you were putting the side plates on you didnt tighten down and you attached handle then tightened. you were checking for binding ?
@ShorrockPaul8 ай бұрын
Have you ever done any shimming on these reels ?
@Roddreel5 ай бұрын
No sir
@Walet_ibu11 ай бұрын
😂😂😂 hancurlah reel servis kasar banget motor kalee di servis