Polaris RZR Pro R & Turbo R Dual-Rate Spring Kit // INSTALL

[@andysmith5290]

Do all the same measurements apply for Walker Evans shocks as well?

[@AmericansFirstJones]

I’m surprised that this customer didn’t have the spring fork & retainer upgraded as well.

[@ronyates7420]

Why the change in ride height from the original install video? Before it was 18.5”front, rear 18”.

[@ShockTherapyllc]

All our testing shows better turning with zero negative in the whoops

[@joeymorris9866]

@@ShockTherapyllc what mode are you in when measuring ride height? Thank you!

[@ShockTherapyllc]

@@joeymorris9866 You want to be in the softest setting so the car can settle out completely.

[@Cosmicsurfpro]

I'm shocked!!! 🤙🏻😎

[@d.bray1]

So, what’s the starting Rear preload and crossover settings for a turbo R because these cannot be right for both models can they? Installing my set up now (turbo r springs) and it’s not even close. Written instructions had no note for difference in the rear of the pro r and turbo r either.

[@bcgunner9324]

Why wait for the initial suspension to settle before tourqing the bolts? Why not torque while still up in the air?

[@ShockTherapyllc]

Because it’s easier to pull the shocks off to adjust pre load than leave them on and do it by hand.

[@carbondash]

What's the torque setting on the Fork bolt?

[@ShockTherapyllc]

100 ft lbs. 🤘🏻

[@TheCloudpuncher]

Will this spring kit help with the rattling over bumps I get from the front from day one with my Pro R Ultimate? Drives me nuts!!!!!

[@ShockTherapyllc]

Absolutely, smooths out chop and chatter.

[@TheCloudpuncher]

@@ShockTherapyllc Thanks for the reply! Making an order tonight!

[@kirkjansen9923]

What coil compressor is that?

[@ShockTherapyllc]

Jack tech. Amazon🤘🏻

[@four4bigfoot]

Is this the jack tech 3000?? Thanks

[@ShockTherapyllc]

@@four4bigfootyes sir

[@geraldmaez9672]

DOES YOU GUYS SHOCK SPRINGS COME IN BLACK

[@ShockTherapyllc]

No. Silver only

[@geraldmaez9672]

THANK YOU

[@TwistedOff]

👍

[@d.bray1]

DO NOT USE THESE PRELOAD AND CROSSOVER STARTING POINTS FOR A TURBO R WALKER EVANS CAR. At the time of posting this ST still does not have instructions for walker evans pro/turbo r or walker events pro r cars. These are starting points for a Walker Evans Turbo R from ST support. Front Preload- 1.5” Crossover-3.25” Final ride height-17” (driver in car) Final crossover once preload is set for ride height- 1-1.5” crossover gap (bottom of crossover ring to top of plastic spring divider) Rear Preload-2.5” Crossover- 7” Final ride height- 16.5” (driver in car) Final crossover once preload is set for ride height- 3" crossover gap (bottom of crossover ring to top of plastic spring divider)