Ski-Doo R-Motion Suspension Full Bearing + Slider Replacement

[@davidwydysz6342]

I like the sign you have in the shop

[@Schneids15]

Thank you. Me too

[@our87ranger]

Great video, best i have seen to date. Thanks,John

[@terrytuepah171]

Hey thanks for the great vid just picked up a 2015 800 iron dog can’t wait for the snow

[@timothyknight9043]

If you have a table saw in your shop you can use the 7/8 wrench you use to change out the blades.

[@Schneids15]

Great idea

[@djofulll]

What grease did you use for the bearings. First time swapping the bearings on my wheels would like to do it right and extend the life like you said.

[@Schneids15]

Any grease that is a certified wheel bearing grease will work. Of course a waterproof grease would be better. But not necessary.

[@djofulll]

@@Schneids15 awesome thanks. Just found your channel last night. Definitely subscribed.

[@shavedape]

@@Schneids15 it should be low temp grease too though maybe all wheel bearing grease is also low temp (since wheels operate in winter). I usually use Amsoil low temp though there are of course many others that say 'low temp' on them. Don't the bearings come pre-lubed or do they not put enough in? You probably said in your video but missed it since I have only skimmed it until I do the job.

[@spencelake1484]

when u hammer in the new bearings, you should NOT hammer on the inner race, you should use a socket that is size of outer race, or use an old bearing

[@Schneids15]

I agree if you were going into a tight tolerance metal holder but with these plastic wheels they are so forgiving you barely put any force on them. Proper would be that way though yes

[@tinman4786]

Yes i agree , sloppy tolerance on those idler wheels, nice but skeptical!

[@MyTimmy75]

Boy. Those wheels and rear shaft sure didn't come out as easy as yours on my 20 year old MXZ ;)

[@BlueRage]

Did you use rivets for your Quick Adjuster covers or hardware?

[@Schneids15]

Mine have been reto’d to bolts.

[@BlueRage]

@@Schneids15 Thanks. I'm doing this now on two XRS's. It's not a fun job in cold!

[@cmjunior77]

Do you have a video on how to remove the full skid with the quick adjust?

[@tomislavlulic9330]

Can someone tell me why my 2016 skidoo 800 renegade has 4 wheels in the back ? Everyone I see has 3....did previous owner upgrade or something ?

[@Schneids15]

It is for sure better. I would think it is an upgrade but maybe the renegades come with 4 because of the longer track? I’m unsure. Definitely a nice upgrade.

[@stevelovell7727]

I will ALWAYS be a Subscriber

[@ethanaustin2706]

Just my opinion though way way faster to pull whole skid from getgo

[@Schneids15]

It can be yes. Hard for me to pull with my lift. Plus if i pull it i have to spend a ton of time pulling the clicker and quick adjust system off

[@normdickson2438]

I would have pulled the complete suspension out rebuilt it and then reinstalled it all together