SKippy's Guillows Spitfire RC Conversion

[@michaeldelory4708]

Try using a very high grit sandpaper and block to remove the die cut parts from the sheet. Lay the sheet flat, turn it over (print side down) and lightly sand the sheet until the die cuts are visible, gently remove the part from the sheet.

[@srknight307]

Thank you I will for my next build as it isn’t LC 🤞

[@DoctorMangler]

Nice work I can't wait to try this. I've been flying parkzone foamies and I really like them, great features for a novice airplane pilot even with 4 channels. I've built the Guillows since I was a kid and it was always my dream way back then to have them really fly on something other than rubber. Beautiful airplanes and thanks for the great tips, it's fun to see your elegant birds fly!

[@srknight307]

Thank you for the kind words and good luck with yours! 👍🏻

[@timtheplaneman]

Very informative. Great video.

[@petermoran3041]

Thanks for posing this very nice descriptive video srk, and the restful music aided viewing! Admire your skills....just ordered my VMC Balsa Basics kit...some of your mods could well be useful in my build.

[@srknight307]

Thanks Peter, I’m trying some different styles of video at the mo. That VMC kit builds well, good luck!

[@petermoran3041]

@@srknight307 Thanks for the encouraging support! Returning to modelling after some 45 yrs I had to learn to dump ic engines and embrace electrics! The VMC Spitfire is maybe a bit too intermediate for me really as previously I only flew very simple RCs with the most simple of controls and often crashed the damn things! I'm hopeful that I can get used to it again and start simply and not be too overconfident....I don't want to break it to early on! Good luck with the vids! Pete

[@tomcook5813]

My apologies for missing it, but what are you using for covering?

[@srknight307]

I’m using the tissue that came in the kit, used a spray undercoat then airbrushed acrylic paints covered with an acrylic varnish 👍🏻

[@tomcook5813]

@@srknight307 nice work☺️

[@srknight307]

👍🏻 thank you 😊

[@ENGIEBENJY]

wow what a build! how long did it take you?

[@srknight307]

Thank you! I didn’t measure it in hours, but a couple of weeks on and off 👍🏻

[@jankordaat]

Hi, nice builds. Question, when you make your own parts do you glue the paper to the wood and if so with what kind of glue and how do you get it off?

[@srknight307]

I just use a dab of pritt-stick or uhu glue stick. Don’t leave it on too long then peel or gently sand if any stays stuck.

[@timtheplaneman]

Could I suggest you post the specs for the electronics in the description?

[@srknight307]

Thanks Tim, the specs have been added to the description.

[@johnferguson7418]

What is the all up flying weight?

[@srknight307]

She’s 340 grams

[@hazen7645]

Nice build. Is the prop and spinner a kit or separate components?

[@srknight307]

Thanks. They are separate components: 37mm spinner and a 6x4 APC prop